Abstract:The wetting behaviour of surfaces is important for various applications like super-hydrophobic surfaces, enhanced oil recovery, mining of metal ores and anti-icing surfaces etc. For rough surfaces, which are the rule rather than the exception, designing textured surfaces that have wetting properties tailored to suit these applications generally involves either bio-mimicry or trial and error. Existing wetting theories such as the well-known Wenzel (1936) and Cassie & Baxter (1944) models do not predict wetting regimes and importantly, only give a single equilibrium angle rather than a range of stable contact angles (hysteresis) as observed in reality. In this paper, we use a roughness-scale mechanical energy balance (derived in part I) combined with simulations of micro-scale interface dynamics based on open-source software (Surface Evolver (Brakke 1992)) to calculate the energy dissipation during the motion of an interface over a chemically homogeneous rough surface. This dissipation is used to predict contact angle hysteresis (CAH) from knowledge of just the surface roughness topography and equilibrium contact angle. We simulate interface dynamics over a surface decorated with a periodic array of round-edge square pillars and show that the energy dissipated varies approximately as ${\phi}ln{\phi}$ with the area fraction (${\phi}$), and becomes zero as ${\phi} \to 0$. The CAH predicted by our method is in good agreement with the experimental results of Forsberg et al. (2010), especially at low area fractions. We also compute CAH for an interface moving at 45$°$ to the surface periodicity direction, showing that the experimental measurements are bracketed by the 0$°$ and 45$°$ advance direction results.

Contact Angle Hysteresis Due to Electric Inhomogeneity of Topographical Patterning of Dielectric Layer in Electrowetting

Frequency-dependent Contact Angle Hysteresis in Electrowetting

Observation of contact angle hysteresis due to inhomogeneous electric fields

Decreasing the Saturated Contact Angle in Electrowetting-on-Dielectrics by Controlling the Charge Trapping at Liquid-Solid Interfaces

Hysteresis and Saturation of Contact Angle in Electrowetting on A Dielectric Simulated by the Lattice Boltzmann Method

Contact angle hysteresis and oil film lubrication in electrowetting with two immiscible liquids

Modulation of wetting state switching of droplets on superhydrophobic microstructured surfaces by external electric field

A Linear Regime of Hysteresis for Calculating the Dynamic Contact Angle under Low Capillary Numbers with Displacement Experiments in Microscale PDMS Microchannels

Electrowetting‐on‐Dielectrics: Decreasing the Saturated Contact Angle in Electrowetting‐on‐Dielectrics by Controlling the Charge Trapping at Liquid–Solid Interfaces (adv. Funct. Mater. 18/2016)

Electrowetting on a Dielectric Surface Roughened with Zinc Oxide Tetrapod Nanocrystals

Electrowetting on dielectrics on lubricating fluid based slippery surfaces with negligible hysteresis

Electrowetting hysteresis on a deformable dielectric film

Contact Angle Hysteresis on Rough Surfaces Part II: Energy Dissipation via Microscale Interface Dynamics

Understanding contact angle hysteresis on an ambient solid surface

Influence of Polarization on Contact Angle Saturation During Electrowetting

Contact Angle Hysteresis at the Nanoscale: A Molecular Dynamics Simulation Study

Simulation of Spreading Dynamics of a EWOD Droplet with Dynamic Contact Angle and Contact Angle Hysteresis

Nanoparticles modulate contact angle hysteresis in electrowetting

Dynamic contact angle hysteresis in liquid bridges

Statistical Mechanics of Electrowetting

Instability of Electrowetting on a Dielectric Substrate