Abstract:<p>A soft open point (SOP) is a flexible power electronic device that can enable accurate active and reactive power flow control to balance the power flow in a distribution network. Due to the inclusion of renewable energy resources with intermittent characteristics in distribution networks, frequent power adjustments and parameter perturbations present great challenges for the control systems of SOPs. Thus, to fully use the regulatory capabilities of the converters in SOP systems and avoid reaching the voltage limits, an adaptive voltage droop control scheme for the outer control loop that considers both a power sharing factor and a DC voltage deviation factor is proposed. Subsequently, a sliding mode control strategy with feedback linearization of the modular multilevel converters (MMCs) is introduced to the inner control loop, thereby improving the robustness of the system and reducing the difficulty of parameter tuning relative to proportional-integral (PI) control. In addition, this paper investigates the zero-dynamics stability of the proposed controller. By combining the two parts of the control system, a control strategy for SOPs based on adaptive voltage droop outer-loop control and sliding mode inner-loop control with feedback linearization is proposed. Case studies of a three-port SOP in a distribution network are conducted to verify the effectiveness and efficiency of the proposed controller.</p>

Switch Process Analysis for Supply Restoration Using a Novel Hybrid Soft Open Point

Transient Analysis on Transfer Process of Hybrid Soft Open Point under Power Grid Outage

An Adaptive Power Control Method for Soft Open Points Based on Virtual Impedance

Transient Analysis and Overcurrent Limited Strategy for Supply Restoration-Oriented Hybrid Soft Open Point

Switch control method based on switch table decision of hybrid system composed of APF and TSC

Operating principle of Soft Open Points for electrical distribution network operation

Switching Technology of Three-Terminals Soft Open Point Control Mode

Series–Shunt Multiport Soft Normally Open Points

Control strategies for active distribution networks based on soft open point

Design and operation of Hybrid Multi-Terminal Soft Open Points using Feeder Selector Switches for flexible distribution system interconnection

Research On An Improved Droop Control Strategy For Soft Open Point

A control strategy for soft open points based on adaptive voltage droop outer-loop control and sliding mode inner-loop control with feedback linearization

An Overview of Soft Open Points in Electricity Distribution Networks

Short-Circuit Fault Protection Scheme for Serial-Shunt Type Soft Normally Open Point

Optimized Two-Time Scale Robust Dispatching Method for the Multi-Terminal Soft Open Point in Unbalanced Active Distribution Networks

Design of a Medium Voltage AC Fast Solid-State Transfer Switch

A Multi-port Converter Based on a Delta-type Cascaded H-Bridge for Soft Normally Open Points

Load Shedding Method of Power Restoration of Distribution Network Based on SOP

Topology Selection and Operation Strategy Design of the Soft Open Point in Looped Distribution Networks

Control Strategy of Multi-level Converters for Soft Open Point Applications

A Two-Layer Control Strategy for Soft Open Points Considering the Economical Operation Area of Transformers in Active Distribution Networks