Abstract:Novel energy generation technologies, such as high-permeability wind power and photovoltaic systems, exhibit inherent intermittency, randomness, and volatility. During periods of energy production from these sources, the impedance of the electrical grid frequently experiences significant fluctuations. Consequently, the grid manifests characteristics akin to a weak grid, highlighting the challenges associated with integrating renewable energy sources with variable output profiles. These fluctuations lead to a shift in resonance spikes of the LCL-type filter towards the lower frequency band, consequently impacting the stability of inverter grid connections. To mitigate this issue, the present study introduces a novel approach integrating the D-split method and a proportional–differential feedforward strategy. This combination aims to reshape the inverter's output impedance, ensuring its consistent stability even amidst significant fluctuations in grid impedance. In this research, the optimal controller parameters for systems operating under robust grid conditions are initially determined. This selection process involves the application of the D-split method, supported by graphical visualization. Additionally, the amplitude and phase angle margin tester is employed while considering the system bandwidth as a limiting constraint. Moreover, accounting for the influence of grid impedance, the D-split method is reapplied to ascertain the most suitable values for the proportional–differential feedforward parameters. This adjustment aims to enhance the adaptability of the grid-connected inverter specifically in scenarios characterized by a weak grid. The hardware-in-the-loop (HIL) simulation results demonstrate that despite the presence of harmonics within the grid and a short circuit impedance ratio (SCR) of 3, the inverter maintains grid stability and effectively suppresses harmonics. Moreover, the total harmonic distortion factor (THD) of the grid-connected current remains below 5%.

Comprehensive and Robust Parameter Design of Grid-Forming Converter with Inner Dual-Loop under Weak Grid Condition

Impedance Analysis and Parameter Optimization of GFM Converter Based on Sensitivity Analysis

H∞-Control of Grid-Connected Converters: Design, Objectives and Decentralized Stability Certificates

Optimized Parameter Design of the Dual-Loop Control for Grid-Forming VSCs With LC Filters

Passivity-Based Stability Design of LCL-Filtered Converters: an Overview

Design Method of Control Parameters for PCS Grid-Connected Mode Based on the Stability Analysis of Islanding Switching

Parameters design and optimization of dual-loop controller for grid-connected inverters with LCL filters

Design of LCL-type Grid-connected Converter Current Loop Controller Parameters Considering Effects of Phase Locked Loops

On Power Control of Grid-Forming Converters: Modeling, Controllability, and Full-State Feedback Design

Robustness Evaluation for Harmonic Suppression of LCL-type Converter Based on Converter-Side Current Feedback Strategy under Weak and Distorted Grid

Modeling and Stability Analysis for Grid-Forming Converter in a Renewable Energy Generation System

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Transient Synchronization Stability Modeling and Analysis of Grid-Following Converter Considering Current Dynamics

Generalized Multivariable Grid-Forming Control Design for Power Converters

Grid-Forming Converter Overcurrent Limiting Strategy Based on Additional Current Loop

Designing Parameters to Reshape the Inverter Output Impedance Based on the D-Split Method under Weak Grid Conditions

An Integrated Design Approach For Lcl-Type Inverter To Improve Its Adaptation In Weak Grid

Integrated Design of Filter and Controller Parameters for Low-Switching-Frequency Grid-Connected Inverter Based on Harmonic State-Space Model

Investigation on Grid-Following and Grid-Forming Control Schemes of Cascaded Hybrid Converter for Wind Power Integrated with Weak Grids

Parameter Designing Method of Active Damping LCL Filter For Grid-Connected Inverter

A Novel Parameter Design Method Of Dual-Loop Control Strategy For Grid-Connected Inverters With Lcl Filter