Abstract:In situ straining was used to study deformation behavior of hexagonal close-packed (hcp) metals. Twinning and dislocation motion, both essential to plasticity in hcp materials, were observed. Typically, these processes are characterized postmortem by examining remnant microstructural features after straining has occurred. By imposing deformation during imaging, direct observation of active deformation mechanisms is possible. This work focuses on straining of structural metals in a transmission electron microscope (TEM), and a recently developed technique that utilizes familiar procedures and equipment to increase ease of experiments. In situ straining in a TEM presents several advantages over conventional postmortem characterization, most notably time resolution of deformation and streamlined identification of active deformation mechanisms. Drawbacks to the technique and applicability to other studies are also addressed. In situ straining is used to study twin boundary motion in hcp magnesium. A 101¯2$$ \left\{ {10\bar{1}2} \right\} $$ twin was observed during tensile and compressive loading. Twin-dislocation interactions are directly observed. Notably, dislocations are observed to remain mobile, even after multiple interactions with twin boundaries; this result suggests that Basinki’s dislocation transformation mechanism by twinning is not present in hcp metals. The coupling of in situ straining with traditional postmortem characterization yields more detailed information about material behavior during deformation than either technique alone.

Characterization of the Terrace-Defect Interfaces Using in Situ Straining Techniques

Revealing interface-assisted plastic anisotropy <i>via in situ</i> transmission electron microscopy tension of lamellar TiAl

In Situ Atomistic Observation of Grain Boundary Migration Subjected to Defect Interaction

Effect of Interface Type on Deformation Mechanisms of Γ-Tial Alloy under Different Temperatures and Strain Rates by Molecular Dynamics Simulation

Quantitative Characterization by Transmission Electron Microscopy and Its Application to Interfacial Phenomena in Crystalline Materials

Tuning the physical properties of ultrathin transition-metal dichalcogenides via strain engineering

Transmission Electron Microscope In Situ Straining Technique to Directly Observe Defects and Interfaces During Deformation in Magnesium

In-situ Transmission Kikuchi Diffraction Nano-tensile Testing

Strain Induced Defect Superstructure on the Surface

In Situ Structural Dynamics of Atomic Defects in Tungsten Oxide

Insights into fundamental deformation processes from advanced in situ transmission electron microscopy

In-situ TEM Observation of the ITB Evolution in Aluminum Deformation Twinning

Interface Dislocation Trajectory and Long-Range Strain Associated with the Migration of Semicoherent Interfaces

A Feasible Surface Patterning Method for SEM-DIC: Achieving High-Resolution In Situ Mapping of Local Strain and Microstructure to Reveal the Effect of Slip Transfer on Shear Strain Near Grain Boundaries

Atomic-scale observation of the deformation and failure of diamonds by in-situ double-tilt mechanical testing transmission electron microscope holder

Strain Partitioning Behavior of in Situ Ti5Si3/TiAl Composites

In-situ synchrotron X-ray micro-diffraction investigation of ultra-low-strain deformation microstructure in laminated Ti-Al composites

Atomic-scale characterization of structural heterogeny in 2D TMD layers

Strain-induced Defect Superstructure on the SrTiO3(110) Surface.

Intermitted 3D diffraction tomography combined with in situ Laue diffraction to characterize dislocation structures and stress fields in micro bending cantilevers

Revealing the atomic-scale evolution of sessile disconnections on twin boundaries during deformation