Abstract:Fiber-optic gyroscopes, as rotational motion sensors, have emerged as powerful candidates for rotational seismology and Earth rotation observation due to their portability and high sensitivity. However, the stability of fiber-optic gyroscopes is degraded by environmental temperature variation that optical fibers are sensitive to. For the suppression of effects of temperature variation, conventional methods include the device level and post-processing level. However, the former has additional device requirements and higher costs, while the latter has a degradation of compensation for a more general environment. In this abstract, we propose a suppression method at the device level. We find that the effect of thermally induced phase fluctuations is significantly lower in the high-frequency band compared to the low-frequency band. Therefore, by upconverting the operating point of the fiber-optic gyroscope at a high-order harmonic of eigenfrequency, the effect of thermally induced phase fluctuations on the output is greatly suppressed. This method is easy to operate without requiring any additional optical or electrical components. To validate this method, we have conducted a time-varying temperature variation experiment using a portable fiber-optic gyroscope equipped with a 20 km long and 0.3 m diameter fiber-optic coil. The implementation of this upconverted frequency modulation technology resulted in a 32-fold reduction in temperature sensitivity for the fiber-optic gyroscope. The results demonstrate that the proposed technology enhances the temperature adaptability of fiber-optic gyroscopes, which is a critical aspect in practical geophysical applications. At the same time, the self-noise is reduced from 3×10-8 rad/s/√Hz to 8×10-9 rad/s/√Hz, further improving its sensitivity to observe geophysical rotation signals. Seismic records will be presented to demonstrate its utility in rotational seismology.

Differential-mode and common-mode measurements based on fiberoptic gyroscopes

Differential-mode and Common-Mode Measurements Based on Fiber-Optic Gyroscopes

Digitalization Study on Test System of Fiber Optic GYRO

Performance Analysis of an Optical Passive Ring-Resonator Gyro with A Hollow-Core Photonic Bandgap Fiber Sensing Coil

Experimental Study and Analysis of High Sensitivity Interferometric Fiber Optic Gyroscope Using Multi-Core Fiber

The New Demodulate Technology of Fiber Optics Gyroscope

Suppression of self-noise and environmental disturbances by fusion in fiber-optic gyroscopes for precision measurement

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

An Open-Loop RFOG Based on Harmonic Division Technique to Suppress LD's Intensity Modulation Noise

Efficient Common-Mode Noise Suppression for Fiber-Optic Interferometric Sensor Using Heterodyne Demodulation

Cooperative Four-State Modulation for Sensitivity Enhancement in a Fiber Optic Gyroscope

Self-suppression of common-mode noises of the different fiber optic interferometric accelerometers

Improving the Performance of Broadband Source-Driven Resonant Fiber-Optic Gyroscopes

Suppressing Backscattering Noise of a Resonant Fiber Optic Gyroscope Using Coherent Detection.

An Effective Suppression of Relative Intensity Noise for Fiber-Optic Gyroscopes with Harmonics Demodulation

Performance of a Resonant Fiber-Optic Gyroscope Based on a Broadband Source

Resonant Fiber Optic Gyro Based on A Sinusoidal Wave Modulation and Square Wave Demodulation Technique

Fiber-optic Gyroscopes with Enhanced Temperature Adaptability for Geophysical Rotational Sensing

Reduction of relative intensity noise in a broadband source-driven RFOG using a high-frequency modulation technique

Common-Mode Noise Suppression Technique in Interferometric Fiber-Optic Sensors

Improved Fusion Algorithm for Fiber-Optic Gyroscope: Suppressing Intrinsic Noise and Environmental Disturbances