Fabrication of Defect-Free Ferroelectric Liqid Crystal Displays Using Photoalignment and Their Electrooptic Performance

Ryuji Kurihara,Hirokazu Furue,T. Takahashi,Tadahiro Yamashita,Jun Xu,Shunsuke Kobayashi

DOI: https://doi.org/10.1143/jjap.40.6679

IF: 1.5

2001-01-01

Japanese Journal of Applied Physics

Abstract:A photoalignment technique has been utilized for fabricating zigzag-defect-free ferroelectric liquid crystal displays (FLCDs) using polyimide RN-1199, -1286, -1266 (Nissan Chem. Ind.) and adopting oblique irradiation of unpolarized UV light. A rubbing technique was also utilized for comparison. It is shown that among these polyimide materials, RN-1199 is the best for fabricating defect-free cells with C-1 uniform states, but RN-1286 requires low energy to produce a photoaligned FLC phase. We have conducted an analytical investigation to clarify the conditions for obtaining zigzag-defect-free C-1 states, and it is theoretically shown that zigzag-defect-free C-1 state is obtained using a low azimuthal anchoring energy at a low pretilt angle, while a zigzag-defect-free C-2 state is obtained by increasing azimuthal anchoring energy above a critical value, also at a low pretilt angle. The estimated critical value of the azimuthal anchoring energy at which a transition from the C-1 state to the C-2 state occurs is 3×10-6 J/m2 for the FLC material FELIX M4654/100 (Clariant) used in this research; this value is shown to fall in a favorable range which is measured in an independent experiment.