Abstract:High volume bus facilities range from on-street facilities to dedicated Bus Rapid Transit (BRT) facilities. The aim of this study is to better understand performance by directly relating critical stop bus capacity to quality of service (QOS), which measures performance from the passengers’ and operator’s perspectives. The US transit capacity and quality of service manual methodology estimates facility bus capacity based on critical stop operation using a failure rate approach. However, this approach is inaccurate under high volume conditions and the failure rate is a difficult measure to prescribe and to interpret. This research provides an improved understanding of operation by instead considering bus upstream average waiting time to measure capacity and QOS performance, because it is experienced directly by passengers and is an indicator of the impact upon general traffic. A fundamental microscopic simulation model is developed with many bus stop operational aspects occurring stochastically, including upstream arrivals. An empirical upstream average waiting time model is calibrated for five bus stop scenarios including BRT and on-street conditions. This is then used to determine working capacity based on QOS threshold upstream average waiting time. Assigning a worse threshold gives diminishing returns in working capacity, particularly for waiting times beyond 60 s. For an assigned threshold, as loading area processing time reduces, working capacity increases more markedly. This demonstrates that BRT stations are more productive than general on-street bus stops. An example shows that a policy decision exists for the operator as to which QOS threshold to accept in balance with working capacity that suits the desired schedule. It is also discussed that the model enables the operator to evaluate the impact of design or operational changes as well as timetable changes on capacity and QOS.

An Empirical Assessment of Interactions Between Bus Rapid Transit and General Traffic Flows

Investigations of Interactions Between Bus Rapid Transit and General Traffic Flows

Planning for Bus Rapid Transit in Single Dedicated Bus Lane

Simulation Study of Dedicated Bus Lanes on Jingtong

Integrated Control of Internal Boundary and Ramp Inflows for Lane-free Traffic of Automated Vehicles on Freeways.

Evaluation of Cost-Effective Planning and Design Options for Bus Rapid Transit in Dedicated Bus Lanes

Developing a dynamic utilisation scheme for exclusive bus lanes on urban expressways: an enhanced CTM‐based approach versus a microsimulation‐based approach

Integrated Robust Optimization of Scheduling and Signal Timing for Bus Rapid Transit

Bus signal priority method at arterial signal progression

Evaluating the Environmental Benefits of Median Bus Lanes: Microscopic Simulation Approach

Real-time Arterial Performance Measurement Using Signal Timing Data and BRT As Probes

Real-time arterial performance measurement using BRT probe data and signal timing data

The Competition Relationship Analysis on BRT and Rail Transit in Urban Integrated Transportation System

Bus rapid transit as arterial corridor traffic calming: The relationship between transit infrastructure and motor vehicle operating speeds

Delay model in two-lane traffic flow induced by buses

Drivers of Bus Rapid Transit Systems – Influences on Patronage and Service Frequency

Research on the multiroute probit-based public transit assignment model based on bus stop

Modeling and Control of Automated Vehicle Access on Dedicated Bus Rapid Transit Lanes

Development and evaluation of bus lanes with intermittent and dynamic priority in connected vehicle environment

High volume bus stop upstream average waiting time for working capacity and quality of service

An Approach of Transit Passive Priority with Transit Phase Overlapped at Intersection of Arterial Signal Progression