Abstract:The determination of the traffic carrying capacity of road network is of great significance to the scale control of urban vehicles and the control of transportation systems. Existing related works have proposed calculation models and solutions for different application environments. However, these studies have problems such as diversification of capacity definitions, incorrect analysis of factors, and excessive model constraints. In response to these problems, this paper aims to determine the connotation of traffic carrying capacity and put forward a novel calculation model for carrying capacity. Firstly, in-depth analysis found that the key factor affecting the number of vehicles is the service level of road network. Then, the connotation of traffic carrying capacity is clarified, that is, the maximum number of vehicles travelling simultaneously in the road network under a certain service level. Second, based on the definition of carrying capacity and the characterization relationship between average travel speed and service level, the calculation of carrying capacity is transformed into the establishment of relationship between average travel speed and maximum number of vehicles. The construction of this relationship includes five steps, which are proposal of equivalent lane, division of traffic basic units, construction of basic unit travel time model, calculation of basic unit carrying capacity, and calculation of road network carrying capacity. In particular, the proposal of equivalent lane achieves the conversion from intermittent flow to continuous flow, and the abstraction of traffic flow further unifies the operation process into a unified mode of free travel and stacked release. Finally, the VISSIM simulation software is employed to verify and evaluate the proposed models. The results show that the average relative error between the simulated data and the calculated data obtained from the model is -0. 46%. Findings from this study will provide an innovative idea for the evaluation of urban road network performance. It can also provide a basis for urban managers to improve service level of road network and optimize the design of transportation system.

Threshold Values of Traffic Flow for the Provision of Exclusive Bus Lanes

Based on Simulation Method for Solving Traffic Jam Problems.

Delay model in two-lane traffic flow induced by buses

MTCS: A Method of Analyzing the Traffic Capacity of Urban Bus Lane Based on Vissim Simulation

Modeling of urban road network traffic carrying capacity based on equivalent traffic flow

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections

Bus signal priority method at arterial signal progression

Optimal Bus Lane Infrastructure Design

Conditional Active and Passive Bus Signal Priority Strategies Considering Saturation Degree Restriction at an Isolated Junction

Comparative study on simulation performances of CORSIM and VISSIM for urban street network.

Optimizing the numbe r fo buses stopping at on-line stops under mxi ed traffic conditions

Study of the impact of exclusive bus lane under highly heterogeneous traffic condition

Bus Priority on Roads Carrying Heterogeneous Traffic: a Study using Computer Simulation

Simulation Study of Dedicated Bus Lanes on Jingtong

Study on transfer functions model of urban traffic flow at intersection

Modelling Method on Dynamic Optimal Setting and Associated Control for Intermittent Bus Lane

Simulation of the Frontage Road Control Near the Expressway Exit Ramp

Development and evaluation of bus lanes with intermittent and dynamic priority in connected vehicle environment

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Lane-Based Network Data Model for Micro-Traffic Flow Simulation

Traffic flow capacity model for urban expressways