Abstract:The behavior of luminol electrochemiluminescence (ECL) at a polycrystalline gold electrode was studied under conventional cyclic voltammetric (CV) conditions. At least six ECL peaks were observed at 0.28 (ECL-1), 0.56 (ECL-2), 0.95 (ECL-3), 1.37 (ECL-4), −0.43 (ECL-5) and 1.00 (ECL-6, a broad wave after the reverse scan from +1.66) V (vs. SCE), respectively, on the curve of ECL intensity versus the potential. These ECL peaks were found to depend on the presence of O2 and N2, the pH of the solution, KCl concentration, scan rate, and potential scan ranges. The emitter of all ECL peaks was identified as 3-aminophthalate by analyzing the CL spectra. It is believed that ECL-1 at 0.28 V was correlated to luminol radicals produced by the electro-oxidation of luminol anion and ECL-2 at 0.56 V was caused by the reaction of luminol radical anions with gold oxide formed on the electrode surface. ECL-1 and ECL-2 could be strongly enhanced by O2 and O2−. ECL-3 at 0.95 V was likely to be due to the reaction of luminol radical anions with O2 oxidized by OH−. ECL-4 at 1.37 V suggested that OH− was electro-oxidized to HO2− at this potential and then to O2−, which reacted with luminol radical anions to produce light emission. ECL-5 at −0.43 V seems to be due to the reaction of luminol with ClO− electrogenerated at higher positive potential and HO2− electrogenerated at negative potential. ECL-6 was attributed to the reaction of luminol radical anions and ClO− electrogenerated at higher positive potential. The results indicated that luminol ECL can be readily initiated by various oxygen-containing species electrogenerated at different potentials, leading to multi-channel light emissions. Furthermore, the present work also reveals that ECL-2 is a predominant ECL reaction route at a gold electrode with higher potential scan rates under CV conditions.

Electrochemiluminescence in the S 2 O 8 2 - System: PtCd Electrodes

Electrochemiluminescence in the S2O82- System: Pt–Cd Electrodes

Electrogenerated Chemiluminescence of CdS Spherical Assemblies

A Simple and Sensitive Approach to Monitor the Spectrum Change During the Electrochemiluminescence Process and Reveal the Mutual Promotion Between G-C3n4 and Co-Reactant of S2o82-

Electrogenerated chemiluminescence from CdS nanotubes and its sensing application in aqueous solution.

Toward Mechanistic Understanding of Electrochemiluminescence Generation by Tris(2,2′-Bipyridyl)ruthenium(ii) and Peroxydisulfate

Electrochemiluminescence of Luminol on a Platinum-Nanoparticle-modified Indium Tin Oxide Electrode in Neutral Aqueous Solution.

Two electrochemiluminescence pathways of Ru(bpy)3 2+/C2O4 2- system on platinum electrode

Two electrochemiluminescence pathways of Ru(bpy)(2+)(3) /C2O42- system on platinum electrode

Electrochemiluminescence Behaviors of Eu3+-doped CdS Nanocrystals Film in Aqueous Solution

In Situ Activation of CdS Electrochemiluminescence Film and Its Application in H2S Detection

Electrogenerated Chemiluminescence Resonance Energy Transfer Between Luminol and Cds/Graphene Nanocomposites and Its Sensing Application

Electrochromic Response and Electrochemiluminescence of CdS Nanocrystals Thin Film in Aqueous Solution

Coupling O-2 and K2S2O8 Dual Co-reactant with Fe-N-C Modified Electrode for Ultrasensitive Electrochemiluminescence Signal Amplification

Electrogenerated Chemiluminescence of Platinum(ii) Alkynyl Terpyridine Complex with Peroxydisulfate As Coreactant.

ECL—Electrochemical luminescence

Anodic Electrochemiluminescence of Cdse Nanoparticles Coreacted with Tertiary Amine and Halide Induced Quenching Effect

Potential-dependent electrochemiluminescence of luminol in alkaline solution at a gold electrode

Electrogenerated Chemiluminescence Behavior of Tb Complex and Its Application in Sensitive Sensing Cd2+

Amplification Effect of CdS Quantum Dots on Electrogenerated Chemiluminescence of Ru(bpy)(3)(2+) and Its Application in Determination of Catechol

Unraveling Mechanisms of Highly Efficient Yet Stable Electrochemiluminescence from Quantum Dots.