Abstract:As a solution to the most critical problems with Solar power Satellite (SPS) development, a system is proposed which uses laser power transmission in space to a receiver high in the atmosphere that relays the power to Earth by either cable or microwave power transmission. It has been shown in the past that such hybrid systems have the advantages of a reduction in the mass of equipment required in geostationary orbit and avoidance of radio frequency interference with other satellites and terrestrial communications systems. The advantage over a purely laser power beam SPS is that atmospheric absorption is avoided and outages due to clouds and precipitation will not occur, allowing for deployment in the equatorial zone and guaranteeing year round operation. This proposal is supported by brief literature surveys and theoretical calculations to estimate crucial parameters in this paper.In relation to this concept, we build on a recently proposed method to collect solar energy by a tethered balloon at high altitude because it enables a low-cost start for bringing the first Watt of power to Earth giving some quick return on investment, which is desperately missing in the traditional SPS concept.To tackle the significant problem of GW-class SPSs of high launch cost per kg mass brought to space, this paper introduces a concept which aims to achieve a superior power over mass ratio compared to traditional satellite designs by the use of thin-film solar cells combined with optical fibres for power delivery. To minimise the aperture sizes and cost of the transmitting and receiving components of the satellite and high altitude receiver, closed-loop laser beam pointing and target tracking is crucial for pointing a laser beam onto a target area that is of similar size to the beam's diameter. A recently developed technique based on optical phase conjugation is introduced and its applicability for maintaining power transmission between the satellite and high altitude receiver is assessed.It was found that the design of the high altitude receiver and the means of transporting the received power through the lower 21km of the atmosphere are inextricably linked. It was concluded that an initial small scale low-cost demonstration flight of the receiver that delivers power using existing technology could be undertaken in the near future.

High Power Electric Generation and WPT Demonstration Mission

A Proposed MPT Demonstration Mission in Space

Wireless Power Transfer in Space using Flexible, Lightweight, Coherent Arrays

Design of Microwave Power Transmission System for Space Solar Power Station Demonstration

W band solid-state power amplifier for aerospace usage

Research Progress and Future Directions in Deep Space Optical Communication(Invited)

Design And Test Of Microwave Power Transmission System

Preliminary Results and Analysis of Microwave Power Transmission System for SSPS

Beam Steering Design for MW-Level Microwave Power Transmission in SSPS Demonstration

L‐band High Power Solid‐state Power Amplifier for Aerospace Usage

Opportunities and challenges of long-distance high-capacity continuous wireless power transmission

Design and Experiment for Realization of Laser Wireless Power Transmission for Small Unmanned Aerial Vehicles

Experimental research and design of microwave power transmission system for SSPS application

High-Efficiency 2-D Multibeam Rectenna Based on Gain Enhanced Patch Array

Basic Principles of Point-to-Point Omnidirectional Wireless Power Transfer System

Design and on-orbit verification of ZDPS-1A power system

Beam Collecting Efficiency Analysis in Microwave Power Transmission Demonstration System for SSPS

Transmission media appropriate laser-microwave solar power satellite system

Towards Space Solar Power - Examining Atmospheric Interactions of Power Beams with the HAARP Facility

Continuous Power Beaming to Lunar Far Side from EMLP-2 Halo Orbit

Spatial Power Combining In Microwave Power Transmission Systems