Abstract:Side milling thin-walled workpiece edges is an indispensible procedure in the continuous process chains for the high-efficiency machining of thin-walled functional parts, for example, the small- and medium-sized compressor blades. In these operation cases, the workpiece vibration is easy to occur due to the poor stiffness of the thin-walled structures, causing defects to the machined surface finish and even the dimensional accuracy of the thin-walled workpiece edges. To this problem, this study proposes the tool inclination method based on the adaption of the cutting force component in the lowest stiffness direction of the thin-walled workpiece, and it aims, first, to guarantee the machined surface finish which is mostly dominated by the workpiece vibrations mainly induced by the relatively high cutting forces and, second, to guarantee the high machining efficiency. The parametric study on the tool inclination angle for side milling the thin-walled workpiece edges was conducted by using the finite element simulations. First, the finite element models were elaborated and validated by the experimental results in terms of the cutting forces. Then, based on a series of finite element simulations, the effects of the tool inclination angle on the cutting forces adaption and its corresponding mechanism, that is, the chip formation variation, were investigated. Simulation results under the given conditions showed that the optimal tool inclination angle for the minimum absolute value of Fn was 26°. At last, the prediction feasibility for the best machined surface finish when side milling the low-stiffness thin-walled workpiece edges at the optimal tool inclination angle was well validated by the experimental results. The proposed tool inclination method with the solid end mill based on the finite element model to improve the machined surface finish is meaningful and feasible for the high-efficiency manufacturing processes of thin-walled workpieces.

Study on Formation of Exit Edge Defects in the Milling Process by Using the Combined Theory of the Energy Conservation and Orthogonal Cutting Mechanism

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Mechanism and force modeling for cross-edges in the flank-end milling process based on the constrained cutting theory

Systematic Study of the Prediction Methods for Machined Surface Topography and Form Error During Milling Process with Flat-End Cutter

Research on Cutting Edge form Factor of Milling Tool after Drag Finishing Preparation Based on Discrete Element Method

A novel approach of stability and topography prediction in five-axis ball-end milling process through workpiece-edge-coupling

Parametric Study on the Tool Inclination Angle for Side Milling Thin-Walled Workpiece Edges Based on Finite Element Simulation

Tool-edge geometry effects in semi-to-finish cut machining operations on subsurface integrity and tool thermo-mechanical loadings: A coupled damage-fracture energy based finite element approach

Cutting edge preparation using the discrete element software EDEM

Study on formation mechanism of edge defects of high-volume fraction SiCp/Al composites by longitudinal-torsional ultrasonic vibration-assisted milling

Investigation of the tool flank wear influence on cutter-workpiece engagement and cutting force in micro milling processes

Surface form error prediction in five-axis flank milling of thin-walled parts

Experimental and numerical investigation into material removal mechanism of fast ED-milling

Study on the edge defects of high volume fraction 70% SiCp/Al composites in ultrasonic-assisted milling

Three Dimensional Finite Element Simulation and Analysis of Residual Stress in Milling

Modeling and Simulation of Machined Surface Error in Micro-Ball-End Milling

A 3D Analytical Model for Residual Stress in Flank Milling Process

Prediction Model for the Evolution of Residual Stresses and Machining Deformation of Uneven Milling Plate Blanks

A study on exit burr formation in grinding process-Simulation and experiment

High-Quality Machining of Edges of Thin-Walled Plates by Tilt Side Milling Based on an Analytical Force-Based Model

Influence mechanism of machining angles on force induced error and their selection in five axis bullnose end milling