Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Finite Element Simulation of Polymer Melt Flow in Extrusion Molding Processes

Numerical simulation of filling flow of polymer melt in injection molding

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Modeling and simulation of polymer melts flow in the extrusion process of plastic profile with metal insert

A Three-Dimensional Thermal Model for Viscoelastic Polymer Melt Packing Process in Injection Molding

Finite Element and Experimental Analysis of Three-Dimensional Flow State of Plastic Melt in Slit Die Section

Numerical Simulation of Three‐dimensional Polymer Extrusion Flow with Differential Viscoelastic Model

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

Numerical Simulation of Driven and Pressure Flow in Compound Shaped Part of Co-Extrusion Process of Polymer with Metal Insert

Numerical Study of Nonisothermal Polymer Extrusion Flow with a Differential Viscoelastic Model

Numerical modelling of the viscoelastic polymer melt flow in material extrusion additive manufacturing

Numerical Modeling of Thermal Flows in Entrance Channels for Polymer Extrusion: A Parametric Study

Non-isothermal Comprehensive 3-D Simulation on Polymer Melt

The Finite Element Simulation and Analysis of Polymer Tube Coextrusion Process

The Finite Element Simulation of Polymer Coextrusion Based on the Slip Boundary

Continuous Modeling and Simulation of Flow-Swell-crystallization Behaviors of Viscoelastic Polymer Melts in the Hollow Profile Extrusion Process

Numerical Simulation of the Extrusion Forming Dynamic Process of Polymer Material

The Numerical Analysis of the Polymer Melts Flow Through the Gas Assisted Coextrusion Die

Numerical Simulation of the Non-isothermal Viscoelastic Flow Past a Confined Cylinder

Numerical Simulation of Polymer Filling Process by a Combined Finite Element/discontinuous Galerkin/level Set Method