Abstract:Aerosol dosimetry in respiratory airways is relevant for pulmonary drug delivery and inhalation toxicology. Consequently, computational fluid-particle dynamics (CF-PD) modelling of pulmonary aerosol delivery is an active research field. Additionally, mice are the most commonly used animals in medical research. Technological advances have provided information on whole mice lung morphologies with unprecedented high resolution. Therefore, in this study, we used highresolution light sheet fluorescent microscopy (LSFM) images of a healthy C57BL/6 mouse lung with a constant air flow rate of 72 ml/min, to extract an anatomical 3-dimensional (3D) geometry of the entire airway tree of the left lung from the primary bronchi to the most distal bronchioles excluding the trachea. The airways were segmented based on an order- and generation-based method. Also, to compare the morphological data and regional deposition, a generation-based investigation including 25 generations was employed in the present model. One-way coupling of CF-PD modeling was applied to model an intubated and mechanically-ventilated mouse. Maximum values of the velocity and vorticity magnitude of 3.2 m/s and 200,000 1/s were reached in the second order, respectively, and maximum pressure and wall shear stress levels were 30 Pa and 3.5 Pa, respectively. Finally, order- and generation-based particle deposition efficiency and dose per lung area were obtained for the particle size range of 1 mu m <= dp <= 10 mu m yielding pronounced hotspot deposition patterns mainly near the proximal bifurcations. The results showed a positive correlation between deposition efficiency and particle size due to a sizedependent increase in inertial and gravitational effects. Maximum regional deposition and normalized dose was seen for 10 mu m particles in the 1st order of the murine left lung. Smaller peak sizes of deposition efficiency were seen in the third and fourth orders of the mouse left lung due to almost complete loss of the largest particles in lower order airways. It also justifies the close to zero deposition efficiency in the highest orders (fifth to sixth). Both lung morphology as well as total and regional aerosol deposition showed reasonably good agreement with empirical data from the literature. The present CF-PD model with accurate realistic lung morphology, improves our knowledge of airway aerosol deposition hotspots. The obtained modeling method and the qualitative results can be implemented on human airways.

Aerosol Dosimetry in the Whole Conducting Zone of a Murine Left-Lung Using CF-PD and LSFM Images

Regional Aerosol Deposition in the Human Airways: the SimInhale Benchmark Case and a Critical Assessment of in Silico Methods

In Silico Study on the Deposition and Distribution of Particles in a Realistic Airway Model with Handilaher®

Computational analysis of radon progeny deposition patterns in the human respiratory system

Numerical Simulation of Inhaled Aerosol Particle Deposition Within 3d Realistic Human Upper Respiratory Tract

Multispecies aerosol evolution and deposition in a human respiratory tract cast model

Investigation of Ultrafine Particle Deposition in Human Airway to the 9th Generation of Bronchial Tubes Using Computational Fluid and Particle Dynamics

Numerical study on the deposition distribution and mechanism of inhaled drug particles in various regions of the realistic inhaler-airway model

Research on deposition characteristics of on radioactive aerosols in a realistic human model

Three-dimensional simulations of airways within human lungs

A Critical Analysis of the CFD-DEM Simulation of Pharmaceutical Aerosols Deposition in Upper Intra-Thoracic Airways: Considerations on Aerosol Transport and Deposition

CFD–DEM simulation of particle transport and deposition in pulmonary airway

Computational Investigation of Flow Characteristics and Particle Deposition Patterns in a Realistic Human Airway Model under Different Breathing Conditions

Validation of computational fluid dynamics models for airway deposition with SPECT data of the same population

Numerical Modeling of Particle Transport and Deposition in Human Lungs

A critical analysis of the CFD-DEM simulation of pharmaceutical aerosols deposition in extra-thoracic airways

Numerical Investigation of the Lower Airway Exposure to Indoor Particulate Contaminants

An individualised 3D computational flow and particle model to predict the deposition of inhaled medicines - A case study using a nebuliser

Numerical modeling of particle deposition in a realistic respiratory airway using CFD–DPM and genetic algorithm

Simulation on movement and deposition of inhalable contaminant particles in lower respiratory tract

Three-Dimensional Quantitative Co-Mapping of Pulmonary Morphology and Nanoparticle Distribution with Cellular Resolution in Nondissected Murine Lungs