Abstract:In order to obtain the calibration law of rock macro and meso parameters under three-dimensional conditions, based on the parallel bond model, starting with the basic theory of PFC and the qualitative relationship between macro and meso parameters, an orthogonal experimental scheme is designed. An improved BP algorithm is proposed, which has a function with gradient factor, adaptive Nesterov momentum method, and adaptive learning rate for the lightweight analysis of meso parameters. The sensitivity between macro and meso parameters is quantified, and the key meso parameters are screened out. Based on the lightweight model, the correlation and influence mechanisms between macro and meso parameters are analyzed. It was found that the elastic modulus increases linearly with the increase in equivalent modulus. The parallel bond stiffness ratio can inhibit the growth of the elastic modulus, and the elastic modulus decreases greatly when the stiffness is relatively high. There is a linear relationship between Poisson's ratio and stiffness ratio, and the increase in the friction coefficient will cause the nonlinear decrease in it. The strength parameters have an incentive effect on the peak strength. When the tensile and shear strengths of the parallel bond are at a high level, the combination has the most significant effect on the increase in the peak strength. The internal friction angle mainly has a certain influence on the postpeak strength of the rock, because it has a control effect on the particle sliding on both sides of the shear zone when the sample is loaded after the peak. Based on the central composite experimental design and response surface method, a nonlinear model of macro–meso parameters described by multiple subresponse surfaces is obtained. Finally, the mathematical model of parameter calibration is established, and the optimal solution of rock meso parameters is obtained by using optimization techniques. Through the example verification, it was found that the numerical experiment and laboratory test results are close in the stress characteristics, stress evolution, and failure mode of the sample, which proves the effectiveness and reliability of the calibration method. The research results have a certain reference value for PFC parameter calibration.

Mesoscopic Parameter Calibration of Granite Particles Based on Neural Network and Discrete Element Triaxial Numerical Simulation Test

Numerical Modeling of the Relationship Between Mechanical Properties of Granite and Microparameters of the Flat-Joint Model Considering Particle Size Distribution

A Study of Three Intrinsic Problems of the Classic Discrete Element Method Using Flat-Joint Model

Numerical investigation of the effects of the micro-parameters of the transgranular contact on the mechanical response of granite

Calibration of the microparameters of the discrete element method using a relevance vector machine and its application to rockfill materials

The potential of a multi-fidelity residual neural network based optimizer to calibrate DEM parameters of rock-like bonded granular materials

Study on the correlation and calibration of macro and micro parameters of discrete element model for sandstone

A Method for Estimating the Mechanical Parameters of the Laminae of Laminated Rocks Based On Uniaxial Compression and Tensile Tests

Microparameters Calibration for Discrete Element Method Based on Gaussian Processes Response Surface Methodology

Systematical Calibration and Validation of Discrete Element Models for Fiber Reinforced Cement Treated Aggregates

Numerical simulations on the structural heterogeneity and fracture bias effect of three-point bending specimen

A numerical simulation-based ANN method to determine the shear strength parameters of rock minerals in nanoscale

Investigation of the dynamic behavior and fracturing mechanism of granite

Modelling of particle flow code geotechnical material parameter relationships based on orthogonal design and back propagation neural network

Quantitative analysis of grain size effect on tensile mechanical behavior of granite based on multi-level force chain networks

PFC model parameter calibration using uniform experimental design and a deep learning network

Correlations between mineral composition and mechanical properties of granite using digital image processing and discrete element method

Rock Macro–Meso Parameter Calibration and Optimization Based on Improved BP Algorithm and Response Surface Method in PFC 3D

Research on calibration method of microscopic parameters of siltstone based on gray theory

Calibration of the Discrete Element Method and Modeling of Shortening Experiments

Optimizing 3D Granular Modeling with Integrated 3DEC and Neper Techniques for Granite Mechanics Simulation