Coupling Alloyed Lean Lithium Anodes with PIM-1-blended PEO Electrolytes Synergistically Promotes Reversible Li Stripping/deposition Reactions for All-Solid-state Lithium-Metal Batteries

Y. Zhang,X. Lou,J. Dan,C. Franke,L. Tang,J. Li,Z. Gao,L. Zhou,B. Chen,T. Li,T. Liu

DOI: https://doi.org/10.1016/j.est.2024.112399

IF: 9.4

2024-01-01

Journal of Energy Storage

Abstract:All-solid-state lithium batteries with lean (ultrathin) lithium anodes and polymer-based electrolytes e.g., polyethylene oxide (PEO), can potentially offer high energy density, reduced processing cost and improved mechanical contact at electrolyte-electrode interfaces. The non-uniform lithium deposition and inadequate mechanical strength of PEO, however, tend to cause deactivated lithium and short-circuiting by Li dendrites over lithium deposition/stripping cycles; these issues become more aggravated with lean Li anodes due to the more severe volume changes. Herein, we construct a more mechanically and chemically stable lithium-electrolyte interface by coupling alloyed lean Li anodes (<50 mu m) with PEO electrolytes blended with polymers of intrinsic porosity (PIMs). The lean Li anode is fabricated by a facile and scalable cold-rolling method, which leads to a uniformly alloyed lithium anode permitting epitaxial Li deposition. Meanwhile, PIM reinforces the mechanical strength of the PEO composite electrolyte, reducing the likelihood of dendrite formation/penetration. Importantly, the introduction of both GaInSnZn and the first-generation PIM has been found to reduce the interfacial charge transfer resistance via modifying the composition of solid-electrolyte interphase. The resulting full cells with lithium iron phosphate cathodes exhibit a high specific capacity of similar to 160 mAh/g, i.e., similar to 0.6 mAh/ cm(2) with excellent retention of 93.1 % at 120 cycles.