The impact of chain orientation on the melting of the alpha-form of isotactic polypropylene

Manolis Doxastakis,Damilola Ojedeji

DOI: https://doi.org/10.26434/chemrxiv-2024-08988

2024-06-10

Abstract:Isotactic polypropylene (iPP) exhibits polymorphism in the crystalline state that has long being leveraged to tune material properties. It has been established, that even the most prevailing α-iPP can exhibit significant variability with two distinct melting points T m often attributed to α1 and α2 forms. Several structural models with specific ordering in chain orientations and correlations along the crystals have been proposed. Precise structural investigation relies on inverse modeling of diffraction patterns but the impact of thermal history, a potential transition between the two forms and any existence of multiple solutions challenges characterization. Recent detailed atomistic simulations offered a direct route to link postulated structural arrangements to melting transitions with studies focusing to the α1 and β forms of iPP. In this study, we employ atomistic molecular dynamics to examine models of α1 and α2 with variable levels of ordering in terms of chain axis orientation. At rapid heating rates, we find high melting points that can differ up to 30 K depending on the fraction of the material that follows the P21/c structural arrangement. To contrast systems in the absence of superheating, we assembled configurations with free surfaces as well as models of semicrystalline iPP. We report melting kinetics above Tm for the P21/c and Cc crystals and provide Tm estimates in agreement to literature data. In addition, our study provides valuable microscopic information on the dynamics of melting of α-iPP along specific directions.

Chemistry

What problem does this paper attempt to address?

The paper primarily explores the impact of chain orientation on the melting behavior of the α form in isotactic polypropylene (iPP). Specifically, the study focuses on the following points:

1. **Background Introduction**: Isotactic polypropylene exhibits polymorphism, with the most common form being the α form, which can be further divided into two subtypes: α1 and α2. These two subtypes have different physical properties in the crystalline state, particularly in terms of melting points.

2. **Research Objective**: To investigate the melting behavior of α1 and α2 models under different levels of chain axis orientation through molecular dynamics simulations. The study particularly focuses on the effect of heating rate on the melting point and compares the melting kinetics under different structural models.

3. **Methodology**:
- Atomic-level simulation methods are used to study the changes in chain axis orientation in α1 and α2 models.
- Under rapid heating conditions, different melting point temperatures are observed, which depend on the proportion of material following the P21/c structural arrangement.
- To study systems without superheating phenomena, configurations with free surfaces and semicrystalline iPP models were constructed.

4. **Key Findings**:
- Under high heating rates, α1 and α2 models with different levels of chain axis orientation show a melting point difference of up to 30 K.
- For P21/c and Cc crystals, melting kinetics data above the melting point are provided, consistent with estimates in the literature.
- The study also provides microscopic information on the melting dynamics of α-iPP along specific directions.

In summary, this paper aims to deeply understand how chain orientation affects the melting characteristics of the α form in isotactic polypropylene through atomic-level simulation methods, especially under different heating conditions and structural models. The research results contribute to a better understanding of the polymorphism and melting behavior of isotactic polypropylene, potentially guiding the optimization of material properties.