Research on time-varying mesh stiffness analysis method of gears with local defective faults
Jing Tian,Honghai Wang,Zhi Wang,Fengling Zhang,Yu Liu,Renzhen Chen
DOI: https://doi.org/10.1007/s12206-024-1102-0
IF: 1.81
2024-12-06
Journal of Mechanical Science and Technology
Abstract:The TVMS of meshing gears is the important factor affecting the performance of gear systems. Obtaining accurate TVMS is a necessary condition for accurately modeling the dynamics of gear systems. This paper proposes a TVMS analysis method for the actual situation of non-coincidence among the root circle of the gear and base circle, the results of their calculations were compared and analyzed with the Ishikawa formula method and the base energy method, which were 10.73 % and 13.67 % for tooth number 20 and 8.13 % and 9.89 % for tooth number 60, respectively, and the error of the improved energy method was smaller. The method in this paper is used for establishing the calculation formula of TVMS of tooth root crack and flank spalling, and analyze the change rule of TVMS of gears when there are local defects and faults. The results show that the TVMS computation method of gears on the basis of the improved energy method presented in this paper is better than basic energy method, and TVMS obtained is closer to the reality. The proportion of stiffness loss for the maximum depth and inclination of through cracks is 23.6 % and 27 %, respectively, while that of shallow cracks is 8.37 % and 2.8 %, respectively. The proportion of stiffness loss in the interval of stiffness change under the longest spalling length decreases gradually with the increase in the number of teeth, from 7.45 % to 4.63 %, and the proportion of increase in the width of the interval of stiffness loss in the gear under the maximum spalling width rises gradually, from 50.96 % to 51.22 %, but they are all around 50 %.
engineering, mechanical