Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

Axial Force Coherence Study of Servo Steel Strut Loading in Soft-Soil Deep Excavation

Axial force coherence study of strut loading in soft soil deep excavation

Stage-by-stage Control Effect Field Analysis of Steel Material Servo Enhanced Support System on Lateral Displacement and Bending Moment During Deep Basement Excavation

Measurement and Analysis of Deep Foundation Pit Excavation of Adjacent Shield Tunnel with Servo Steel Support

Predicting Wall Deflections for Deep Excavations with Servo Struts in Soft Clay

Deformation Control Monitoring of Basement Excavation at Field Construction Site: A Case of Hydraulic Servo Steel Enhancement Geotechnology

Observed Performance of a 30.2 M Deep-Large Basement Excavation in Hangzhou Soft Clay

Computational Method for Active Earth Pressure of Cohesive Soil under Nonlimit State

Effects of Active Axial Force Adjustment of Struts on Support System during Pit Excavation: Experimental Study

Design and Testing for Steel Support Axial Force Servo System

Observed Performance of a Deep Multistrutted Excavation in Hangzhou Soft Clays with High Confined Water

Analytical Method for the Deformation-Based Design of Retaining Walls in Asymmetric Excavation

Displacement and Force Analyses of Braced Structure of Deep Excavation Considering Unsymmetrical Surcharge Effect

Characteristics of Braced Excavation under Asymmetrical Loads

Earth pressure on supporting structures of asymmetric excavations considering their displacement

Comparison of supporting characteristics of rock-socketed diaphragm walls and non rock-socketed diaphragm walls in soft soil

Force and Deformation Characteristics of Large-Scale Zoning Excavation in Soft Soil: A Case Study in Hangzhou

DEFORMATION CHARACTERISTICS ANALYSIS OF DIAPHRAGM WALL FOR FOUNDATION PIT SUPPORT IN SOFT SOIL

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Observed Performance and FEM-Based Parametric Analysis of a Top-Down Deep Excavation in Soil-Rock Composite Stratum

Base Stability Analysis of Braced Deep Excavation in Undrained Anisotropic Clay with Upper Bound Theory