Abstract:This paper considers the necessary conditions for using a derivative of a transient hot-wire (termed a needle probe) approach to measure the thermal conductivity of electrically conducting fluids at high temperatures, especially molten halide salts. The focus is on the development of a new theory based on a multi-layer system necessary to ensure electrical isolation of electrical wires from the surrounding fluid. This includes the use of a thin annulus of fluid to minimize convective heat transfer modes within the fluid of interest, which was inspired by the concentric cylinder method. Good measurements require the following considerations: concentricity of the probe and surrounding crucible to ensure a consistent fluid gap, accounting for corrections for deviation of the model at early times, and modeling radiation heat transfer through transparent fluids. Uncertainties are larger than transient hot-wire methods because of the deviations from experimental conditions that can easily match an analytical approximation. An appropriate estimation of the measurement uncertainty can be obtained through careful design of the instrumentation, thorough uncertainty analysis, and limiting the measurements to only the applicable thermal property ranges of the approach. The 1D model used to interpret measured temperature data has been shown to be reliable for thermal conductivity measurements ranging from at least 0.39 W (mK −1 ) to 0.92 W (mK −1 ) and for temperatures from 293 K to 1023 K. The approach is used to present thermal conductivity data of the molten salts NaCl–KCl (51–49 mol%) and LiCl–NaCl (72–28 mol%).

IODP Expedition 363 Thermal Conductivity

IODP Expedition 369 Thermal Conductivity

IODP Expedition 351 Bulk Density (GRA)

IODP Expedition 351 Elemental Analysis (CHNS)

Thermal Conductivity Measurement System for Functional and Structural Products

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

A Novel Portable Absolute Transient Hot-Wire Instrument for the Measurement of the Thermal Conductivity of Solids

Electrical Conductivity Measurements Of Aqueous Fluids Under Pressure With A Hydrothermal Diamond Anvil Cell

Electrical Conductivity Relaxation Measurements: Application of Low Thermal Mass Heater Stick

High temperature validation of a line heat source technique for in-pile thermal conductivity determination

Differential heating: A versatile method for thermal conductivity measurements in high-energy-density matter

Thermal Conductivity Measurements for Small Molecule Organic Solid Materials Using Modulated Differential Scanning Calorimetry (MDSC) and Data Corrections for Sample Porosity.

Investigation and Optimization of the Hot Disk Method for Thermal Conductivity Measurements up to 750 °C

IODP Expedition 363 Elemental Analysis (CHNS)

Thermal Conductivity Measurement of the Epoxies and Composite Material for Low Temperature Superconducting Magnet Design

Measurement of Thermal Diffusivity at High Pressure Using a Transient Heating Technique

IODP Expedition 363 Bulk Density (GRA)

Thermal Conductivity of Thermally-Isolating Polymeric and Composite Structural Support Materials Between 0.3 and 4 K

Simultaneous Measurements of the Thermal Conductivity and Thermal Diffusivity of Molten Salts with a Transient Short-Hot-Wire Method

IODP Expedition 376 Magnetic Susceptibility (whole Round)

Experimental Investigation on the Influencing Factors of the Thermal Response Test Using Actively Heated Fiber Optics