Abstract:A 3-slot optical backplane bus demonstrator based on glass substrate with photopolymer volume gratings array (PVGA) on top surface is built to allow 16 channels of data to be broadcast from central slot to two daughter slots or uploaded from any daughter slot to central slot. VCSELs and photodetectors packaged in the form of TO-46 can are assembled on top of each PVG and interleaved to reduce the crosstalk to below noise level. By carefully aligning the fabrication system, the incident angle deviation from Bragg condition is reduced to below 0.1° to maximize optical power delivery. The orientation and period of hologram fringes are uniform in the active area by collimating recording beams. Above 4.8Gbps aggregated data transmission is successfully demonstrated using the multi-channel system. Three computer mother boards using FPGA are made to verify the data transmission among the slots. Interface boards between the FPGA boards and optical transceivers are designed and fabricated to separate the implementation of digital layer and optical layer. Single channel transmissions with 3.2Gbps and even 10Gbps data rate are also tested with above 100uW input power, showing the potential to improve the total two-way bandwidth to above 102.4Gbps. Alignment tolerance of the optical interconnect system is investigated theoretically and experimentally. By analyzing the diffractive characteristics, the bandwidth limit of the optical layer is determined to be in the order of Terahertz. Design and fabrication issues are discussed for future optical backplane bus to make terahertz bandwidth into reality. Based on the experiments for Bit-interleaved Optical Backplane bus and Multi-channel optical backplane bus demonstrators, theoretical analysis of the bandwidth limit of the optical backplane bus using photopolymer volume gratings has been carried out.

Verification of 400 GbE on an FPGA Platform with Optical Modules

106.25 Gbaud On-Off Keying and Pulse Amplitude Modulation Links Supporting Next Generation Ethernet on Single Lambda

Optical Amplification-Free High Baudrate Links for Intra-Data Center Communications

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

400Gbe Technology Demonstration Using CFP8 Pluggable Modules

800 Gbit/s QSFP-DD Transceiver Based on Thin-film Lithium Niobate Photonic Integrated Circuit

Technology research and performance analysis of optical interconnection network based on FPGA

Research on 100Gb/s OTN signal access technology

Verification and Measurement of 40Gps Very Short Reach Parallel Optical Transmission System

Interoperation of 400GBASE-LR8 Physical Interfaces Using CFP8 Pluggable Modules

Laser Communication Test System Based on Ten Gigabit Ethernet

Experimental Demonstration of 10 Gigabit Ethernet-Based Optical Interconnection Network Interface for Large-Scale Computing Systems

High-speed data transfer with FPGAs and QSFP+ modules

Design and Validation of Optical Interconnection Scheme Based on FPGA

3.2Gbps Multi-Channel Optical Backplane Bus Demonstrator Using Photopolymer Volume Gratings

Implementation of 40Gb/s converter for very short reach optical transmission system

High-Speed Real-Time Ofdm Transmission Based on Fpga

10Gbit/s Very Short Reach Parallel Optical Transmission Module and System

2.5D Optoelectronic Integration for 400G (8 × 56gbps) CPO-based Optical Interconnects

High-Speed Serial Optical Link Test Bench Using FPGA with Embedded Transceivers

Net 8×250 Gbit/s/λ PAM6/8 Optical Interconnect Over High-Density Eight-Core Fiber and Low-Crosstalk Laser Direct Writing FI/FO Devices