An Experimental and Kinetic Modelling Study on the Oxidation of NH3, NH3/H2, NH3/CH4 in a Variable Pressure Laminar Flow Reactor at Engine-Relevant Conditions

Zhenyingnan Zhang,Ang Li,Zhuohang Li,Fei Ren,Lei Zhu,Zhen Huang
DOI: https://doi.org/10.1016/j.combustflame.2024.113513
IF: 4.4
2024-01-01
Combustion and Flame
Abstract:Achieving carbon neutrality in ammonia production is feasible through the utilization of green hydrogen generated via water electrolysis using renewable electricity, alongside nitrogen extracted from the air. Ammonia, as an important hydrogen carrier, has attracted increasing attention among researchers as a prospective zerocarbon fuel. However, to enable its utilization in engines, further investigation into the reaction kinetics of ammonia, particularly its co-combustion with other promoters due to ammonia's inherently low reactivity, is imperative, especially under engine-relevant conditions. In this study, oxidation experiments involving pure ammonia, ammonia/hydrogen, and ammonia/methane were conducted within a variable pressure laminar flow reactor. The temperature range spanned 700-1000 K, with pressures ranging between 10 and 30 bar. Experiments were conducted under very lean conditions (0.02 for pure ammonia experiments and 0.05 for ammonia/ hydrogen and ammonia/methane experiments), considering nitrogen, water, and carbon dioxide as final products. The mole fractions of NH3, H2, CH4, O2, NO, NO2, N2O, CO and CO2 were measured using online continuous gas analyzers and GCs. Furthermore, the rate constants of various H-abstraction reactions in the ammonia sub-model were revised based on ab-initio calculations. An updated kinetic model, demonstrating satisfactory predictive performance concerning the oxidation properties of ammonia under elevated pressures, has been proposed. This model is developed based on data from the present work and that taken from other literature. Noteworthy phenomena related to ammonia oxidation were observed in this investigation. Additionally, further experimental and kinetic studies under engine-relevant conditions are advocated to facilitate the development and validation of accurate kinetic models under these conditions.
What problem does this paper attempt to address?