Abstract:<p>Rock abrasivity is an important factor that affects tool wear and tool parameter design, construction efficiency, and cost budgeting during rock excavation. The Cerchar abrasivity index (CAI) is used as a standard parameter to characterize the abrasiveness of rocks. It can be obtained through the Cerchar abrasivity test in a laboratory. However, conventional laboratory Cerchar abrasivity tests and petrophysical and mechanical tests are associated with certain problems, such as long cycles, high costs, and measurement delays, which cannot serve the determination of rock abrasiveness in field. Digital drilling technology is an efficient in situ test method that can effectively link drilling parameters with rock properties. Based on the test results for the CAI and physical and mechanical properties of 13 groups of rock samples collected from southwestern China, this paper focuses on the correlations of the CAI value with rock strength, petrographic characteristics and drilling parameters. By adopting a flat bottom diamond bit that mainly relies on grinding, according to the principle of mechanical balance and energy conservation during rock drilling, the grinding energy per unit volume of rock (ηe) is defined and derived. The univariate regression analysis results show that the uniaxial compressive strength (UCS) and equivalent quartz content (EQC) are the most important factors for explaining CAI and that the CAI can be well estimated using the ηe. Additionally, two optimal regression models for predicting CAI were established using stepwise multiple regression analysis. UCS and ηe were introduced into the model, and the use of both can predict approximately 96% of the variance in the CAI. In addition, a performance evaluation of the models proposed in this paper and previously published CAI prediction models that the prediction models established in this paper are verify statistically more reasonable and reliable than the previously proposed models. The research methods and results provide a new method for the rapid and accurate determination of rock abrasiveness in engineering field.</p>

Extracting Rock Parameters Through Digital Drilling Test

Relationship model for the drilling parameters from a digital drilling rig versus the rock mechanical parameters and its application

Accurate determination of drilling parameters in time series for estimate of rock strengths

A new method for determining strength parameters of rock using digital drilling technology

Strength prediction and drillability identification for rock based on measurement while drilling parameters

Development and Application of a Multifunction True Triaxial Rock Drilling Test System

Upper Bound Analytic Mechanics Model for Rock Cutting and Its Application in Field Testing

Three-dimensional Simulation of Rock Breaking Efficiency under Various Impact Drilling Loads

Regressive and Big-Data-Based Analyses of Rock Drillability Based on Drilling Process Monitoring (DPM) Parameters

Advanced prediction for field strength parameters of rock using drilling operational data from impregnated diamond bit

Investigation of the tool-rock interaction using Drucker-Prager failure criterion

Drilling Process Monitoring for Predicting Mechanical Properties of Jointed Rock Mass: A Review

Relationship between rock drilling parameters and rock uniaxial compressive strength based on energy analysis

Study on a digital drilling test–based rock uniaxial compressive strength measurement method

Rock fracture identification with measurement while drilling data in down-the-hole drills

Regressive and Big-Data-Based Analyses of Rock Drillability Based on Drilling Process Monitoring (<i>DPM</i>) Parameters

Experimental Study on Quantitative Drilling of Composite Rock Mass

Estimation of mechanics parameters of rock in consideration of confining pressure using monitoring while drilling data

Investigation on the relationship among the Cerchar abrasivity index, drilling parameters and physical and mechanical properties of the rock

Experimental study on predicting rock properties using sound level characteristics along the borehole during drilling

A Novel Method for Identifying Rock Interfaces and Fragmentation Zones Based on Drilling Response Characteristics