Abstract:In this study, the process of carbon dioxide (CO2) capture directly from ambient air in a conventional monoethanolamine (MEA) absorption process was simulated and optimized using a rate-based model in Aspen Plus. The process aimed to capture a specific amount (148.25 Nm3/h) of CO2 from the air, which was determined by a potential application aiming to produce synthetic methane from the output of a 2.7 MW electrolyser (593 Nm3/h H2). We investigated the technical performance of the process by conducting a sensitivity analysis around different parameters such as air humidity, capture rate defined as a ratio of moles of CO2 captured during the process to the total mole of CO2 in the feed stream, CO2 loading of lean and rich absorption liquids and reboiler temperature, and evaluated the energy consumption and overall cost in this system. In order to meet the design requirement for standard packed columns, the rich absorption liquid was circulated to the top of the absorber. A capture rate of 50% was selected in this process as a baseline. At higher capture rates, the required energy per ton of captured CO2 increases due to a higher steam stripping rate, required in the desorber, and at lower capture rates, the size of equipment, in particular, absorber and blowers increases due to the need for processing a significantly larger volume of air at the given CO2 production volume. At the base case scenario, a reboiler duty of 10.7 GJ/tCO2 and an electrical energy requirement of 1.4 MWh/tCO2 were obtained. The absorber diameter and height obtained were 10.4 and 4.4 m, respectively. The desorber is found to be relatively small at 0.54 m in diameter and 3.0 m in height. A wash water section installed at top of the absorber decreased the MEA loss to 0.28 kg/ton CO2. However, this increased capital cost by around 60% resulting in CO2 capture costs of $1,691 per ton CO2 for the MEA base scenario. Based on the techno-economic analysis, assuming a non-volatile absorbent rather than MEA thereby avoiding a wash water section, and using an absorption column built from cheaper materials, the estimated cost per ton of CO2 produced was reduced to $676/tCO2. The overall cost range was between $273 and $1,227 per ton of CO2 depending on different economic parameters such as electricity ($20–$200/MWh) and heat price ($2–$20/GJ), plant life (15–25 years) and capital expenditure (±30%). In order to reduce the cost further, the use of innovative cheap gas-liquid contactors that operate at lower liquid to gas ratios is crucial.

A Novel Intercooling Carbon Dioxide Capture Process Using Ionic Liquids with Ultra-low Energy Consumption

Efficient CO<sub>2</sub> capture by a novel deep eutectic solvent through facile, one-pot synthesis with low energy consumption and feasible regeneration

A Water-Lean Triazole Ionic Liquid Biphasic Solvent for Energy-Efficient CO2 Capture Through Reversible Polarity and Intermolecular Hydrogen Bonding

Optimal Design of a Subambient Membrane Separation System with Work and Heat Integration for CO2 Capture

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Simulation and Optimization for Flue Gas CO2 Capture by Energy Efficient Water-Lean Ionic Liquid Solvent

Tailoring Ionic Liquids For Carbon Capture

Carbon Dioxide Capturing in Temperature/Pressure Swing‐Commercial Processes Using Ionic Liquids

Cost and Heat Integration Analysis for CO2 Removal Using Imidazolium-Based Ionic Liquid -ASPEN PLUS Modelling Study

Using Ionic Liquids to Improve CO2 Capture

Reversible and Robust CO2 Capture by Equimolar Task-Specific Ionic Liquid–superbase Mixtures

Optimal computer-aided molecular design of ionic liquid mixtures for post-combustion carbon dioxide capture

Efficient and Energy-Saving Co2 Capture Through the Entropic Effect Induced by the Intermolecular Hydrogen Bonding in Anion-Functionalized Ionic Liquids

Thermodynamic and economic assessment of cyano functionalized anion based ionic liquid for CO2 removal from natural gas integrated with, single mixed refrigerant liquefaction process for clean energy

A novel ionic liquids-based scrubbing process for efficient CO 2 capture

Molecular Simulation and Experimental Study on Low-Viscosity Ionic Liquids for High-Efficient Capturing of CO2

Molecular Simulation and Experimental Study on Low-Viscosity Ionic Liquids for High-Efficient Capturing of CO 2

Techno-Economic Assessment for CO2 Capture From Air Using a Conventional Liquid-Based Absorption Process

Performance of a novel waste heat-powered ionic liquid-based CO 2 capture and liquefaction system for large-scale shipping

Equimolar CO2 capture by imidazolium-based ionic liquids and superbase systems

Multi-dimensional assessment for the novel carbon capture process integrated the low-temperature adsorption and desorption