Abstract:Partial discharge (PD) is not only an important sign of insulation deterioration, but also an important means to detect insulation defects. However, recent operation experience shows that there may be some limitations for the conventional PD detection method, which will result in detection failure. In this paper, a high-sensitivity detection system was established, and the screening tests for the 1100 kV insulators were carried out. Under the PD test condition, the discharge level of good insulators was obtained. Additionally, the experiments of simulated defects and actual defects on the insulator surface were carried out. The results show that under the PD test condition, for the 1100 kV good insulators, the intrinsic PD level is smaller than 0.1 pC. For some micro defects, such as the polish and dirt contaminant on the insulator surface, they will not induce PDs, or even if they provoke PDs, the PDs are only approximately 0.1 pC and even much lower than 0.1 pC. The discharge level of defects such as micro metal particles and cracks on the insulator surface is generally smaller than 1 pC (lower than the conventional detection sensitivity), indicating that there is indeed detection limitation of the conventional detection method. This paper is of great interest for further understanding the intrinsic PD level of good insulators as well as the detection effectiveness of conventional PD detection methods.

An Impulse Voltage-Based Compact Device for Porcelain Insulator Defect Detection

Aminiaturized Device for Detecting Defects of Porcelain Insulators Based on High-Level Impulse Voltage Breakdown

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Feasibility Research of Defect Testing for Basin Insulator Based on Ultrasonic Guided Wave

Research on Zero Value Detection Technology of Porcelain Insulator

Research on Design and Application of Portable UHV Zero Value Insulator Detection Device

Nondestructive Testing Method of Post Porcelain Insulator Based on Pulsed Infrared Thermal Wave Technology

Detection of Internal Defects of Full-Size Composite Insulators Based on Microwave Technique

Detecting Defects in Porcelain Postinsulator Coated with Room Temperature Vulcanized Silicone Rubber by Pulsed Thermography.

Microwave-based Detection of Internal Defects in Composite Insulators for Outdoor Application

Pulsed Infrared Thermography to Inspect the Internal Defects of Composite Insulators

Non-Destructive Testing of Internal Defects in Composite Insulators Using Microwave Technique

Study on Charged Detection Method of Porcelain Insulator in Single Asymmetric Transmission Line

Microwave Detection Technology for Internal Defects of Composite Post Insulators

Study on the nondestructive detection method of composite insulator internal defect based on microwave reflection

Analysis of the Research and Development Status and Future Development of Porcelain Insulator Fault Detection Equipment Based on a Portable Insulator Detection Device

Microwave-based Non-destructive Testing Method on Composite Insulators

Detection of Small Defects in Composite Insulators Using Terahertz Technique and Deconvolution Method

Microwave Reflection Method for Composite Insulator Internal Defect Detection

Partial Discharge Detection of Insultors in GIS: Effectiveness and Limitation