Abstract:Alloy solidification is an important process to control the mechanical properties of engineering products. During solidification, dendrite fragmentation occurs commonly as a key phenomenon to determine the microstructure and to obtain fine grain size. Recently, in situ synchrotron X-radiography technique was developed and applied to observe thermodynamic behaviors such as dendrite growth and fragmentation during solidification. External forces such as mechanical and electromagnetic stirring, and thermal shock were added into the solidification process to investigate their effects on the fragmentation behavior. However, most work conducted in literature focused on qualitative aspects e.g. morphology transition or solute distribution and quantitative investigation such as determining the specific relationship between fragmentation and solidification conditions was rather limited. In this work, the third generation synchrotron X-radiography technique was used to observe the solidification process of an Al-15%Cu (mass fraction) alloy. Experimental conditions including the strength of the pulsed electromagnetic fields, dendrite growth direction and the temperature gradients were varied and the subsequent effect on fragmentation was studied and quantified. A computer program was developed based on Matlab to perform the image processing and measurement. The fragmentation number according to experiments was counted and correlated to the mushy zone depth and local solid fraction. Results showed that a stronger electromagnetic field, growing against gravity and growing at higher velocity would significantly increase the fragmentation number. Furthermore, the fragmentation number followed a Gauss distribution as a function of either mushy zone depth or local solid fraction, and the maximum fragmentation occurred when the-solid fraction was about 0.45. In the end the extent to which caused those statistic results above were analyzed as the necking process due to the velocity field, the cumulative solid due to the gravity field and the liquid flow due to the electromagnetic field.

Quantitative Study of Solid-State Mechanical Mixing by High-Pressure Torsion Based on Image Processing

Mechanical Alloying of Immiscible Metallic Systems: Process, Microstructure, and Mechanism

Eff ects of Diff erent Mechanical Alloying Parameters on Microstructure of High Temperature Nanocrystalline Cu-Ta Alloys

Solid-state alloying in nanostructured binary systems with positive heat of mixing

Solid-State Alloying in Binary Systems with a Positive Heat of Mixing

Effects of electromagnetic stirring and subsequent homogenization treatment on the microstructure and mechanical properties of Al70Zn10Mg10Cu5Si5 multi-component alloy

A Molecular Dynamics Simulation to Shed Light on the Mechanical Alloying of an Al-Zr Alloy Induced by Severe Plastic Deformation

Intermixing of A System with Positive Heat of Mixing at High Strain Rates

Molten Salt Assisted Solidification Nanoprocessing of Al-TiC Nanocomposites

Synergistic effect of gradient Zn content and multiscale particles on the mechanical properties of Al–Zn–Mg–Cu alloys with coupling distribution of coarse–fine grains

QUANTIFICATION STUDY ON DENDRITE FRAGMENTATION IN SOLIDIFICATION PROCESS OF ALLUMINUM ALLOYS

Mechanical alloying in the Fe–Cu system

Coupling Between Deformation and Mass Transport in an Immiscible Alloy at High Shear Strains

Synchrotron X-ray Absorption Studies of Atomic-Level Alloying in Immiscible Mixtures

Forced Atomic Mixing of Immiscible Nb-Ag Alloys by Severe Plastic Deformation

Modeling the dissimilar material flow and mixing in friction stir welding of aluminum to magnesium alloys

Effect of ultrasonic melt processing and Al-Ti-B on the microstructural refinement of recycled Al alloys

Mechanical Alloying: A Novel Technique to Synthesize Advanced Materials

Study on strengthening effects of Zr-Ti-Nb-O alloys via high throughput powder metallurgy and data-driven machine learning

Shear Enhanced Heterogeneous Nucleation in Some Mg- and Al-alloys

Control of Martensitic Morphology in Thermal-Mechanical Processing of Ferrous Alloys