Abstract:In the process of recovering waste heat from molten slag by dry centrifugal granulation, the particle size and morphology of granulated particles are closely related to the liquid film flow characteristics on the surface of the rotary cup. This paper adopts the numerical simulation method to analyze the spreading characteristics of the liquid film on the surface of the rotary cup under the different conditions of the operating parameters, structural parameters of the rotary cup, the modes of slag inlet tube and rotary cup coordination, and the eccentricity, respectively. The results obtained show that when the rotation speed was increased, the thickness of the liquid film on the inclined wall of the rotary cup decreased, and the decreasing trend gradually decreased. When the flow rate of slag was increased by 50%, the liquid film thickness was increased by about 44%, which changed approximately linearly. Moreover, as the initial temperature of the slag decreased, the spreading of liquid film thickened on the surface of the rotary cup. It was also found that the 30°–60° rotary cup inclination angle was beneficial to thin the liquid film. The slag tube diameter/rotator diameter and the dropping height of slag only affected the liquid film thickness near the center of the rotary cup. The slag eccentricity caused the liquid film to appear in the thickened area and thinned area. Finally, a liquid film thickness correlation at the edge of the rotary cup was obtained to predict the liquid film thickness.Graphical AbstractThe picture shows the process of the liquid slag entering and spreading on the rotor surface. This paper mainly introduced some regular information affected by operation parameters, structural parameters, and unstable working conditions.

Unveiling the Dynamics of Free Film Flow of Molten Slag on a Rotating Disk Atomizer: A Modeling Study with Fluctuating Inlet Flow

Film Flow on Rotating Wheel in a Horizontal Twin-Shaft Reactor for Polymer Devolatilization

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Film Formation in a Horizontal Twin-Shaft Rotating Disk Reactor for Polymer Devolatilization

INVESTIGATION OF ATOMIZATION PERFORMANCE ON A CENTRIFUGAL FUEL SLINGER WITH A PHASE DOPPLER ANEMOMETER

Theoretical Analysis of Free-Surface Film Flow on the Rotary Granulating Disk in Waste Heat Recovery Process of Molten Slag

Dynamic film fragmentation in a rotating disk atomizer: A comparative study of fluids with diverse viscosities

Computational study of free surface film flow and subsequent disintegration of a sheet and ligaments into droplets from a rotary disk atomizer

Spinning disk atomization: Theory of the ligament regime

Influence of Rotary Disk Configurations on Droplets Characteristics in Molten Slag Granulation for Waste Heat Recovery

Flow Characteristics of the Liquid Film During Centrifugal Granulation of Liquid Slag on the Surface of Rotary Cup

Three-dimensional axial dispersion dynamics of granular flow in the rolling-regime rotating drum

Numerical Simulation and Experimental Study on Centrifugal Atomization about Blast Furnace Slag

Analysis of flow field characteristics of the three-dimensional staggered rotor and its influence on structural parameters in the wiped film molecular distillation

Granular surface flow in a two-dimensional rotating drum: Particle dynamics simulation

Modelling the film fragmentation of industrial-scale centrifugal granulation of high-temperature molten slag

Ligament Mode Disintegration of Liquid Film at the Rotary Disk Rim in Waste Heat Recovery Process of Molten Slag

Experimental Investigation of Slag Particles of Ligament Mode Disintegration in Spinning Disk Atomizing

Numerical investigation on flow process of liquid metals in melt delivery nozzle during gas atomization process for fine metal powder production

Flow Pattern Transition and Wave Characteristics of Impinging Jet Flow on a Spinning Disk Reactor

Numerical simulation of stable flow dynamics of viscous film on spinning disk surface