Small-strain Folding of Semi-Rigid Elastomer Derives High-Performance 3D-Printable Soft Origami Actuators

Sicong Liu,Fang Chen,Dehao Duanmu,Yaxi Wang,Jianhui Liu,Wenjian Yang,Yuming Zhu,Yige Wu,Juan Yi,Jian S. Dai,Zheng Wang
DOI: https://doi.org/10.1016/j.cej.2024.151462
IF: 15.1
2024-01-01
Chemical Engineering Journal
Abstract:Elastomers with hyperelastic deformation bring prosperity to soft robotics, especially in constituting fluidic actuators, largely due to the merit of large deformation and airtightness. However, the large (typically 0.5-1.5 strain) in-plane stretching of such materials concurrent to motion generation inevitably causes energy loss, hinders force output and accuracy. Particularly, the high nonlinearity of the low-durometer (typically 10A to 30A Shore) hyperelastic elastomers makes the modeling and control of actuators a well-known challenge. In this work, we proposed an alternative approach of using semi-rigid elastomer of significantly larger durometer (70 A-100 A) to create the typical fluidic soft actuator with axial translation, by utilizing small-strain folding to generate motion. Deformation constraints and property programming are combined into a single-piece body, enabling easy fabrication by Selective Laser Sintering 3D-printing and post-treatment for origami patterned structure. Systematic analyses on the principles, modeling and design are presented. The long lifespan (over 1 million cycles), superior output linearity, high energy efficiency (more than 60% increase), and drastically improved force output (more than 98% increase) were validated experimentally, showing high potentials in enabling high-performance soft actuators that are easy to design, fabricate and drive, strong to use, and accurate to control, towards even wider applications.
What problem does this paper attempt to address?