Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Effect of Orifice Position on Bubble Aggregation and Coalescence in Dynamic Rotating Flow

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Bubble Formation in a Swirl-Venturi Microbubble Generator

Experimental Measurement and Theoretical Analysis on Bubble Dynamic Behaviors in a Gas-Liquid Bubble Column

The Influence of Thixotropy on Bubble Growth in Thixotropic Yield Stress Fluids: Insights from Numerical Simulations

Dynamics of bubbles detached from non-circular orifices: Confinement effect of orifice boundary

Bubble refinement by non-invasive rotating flow

Coalescence Characteristics of Bubbles from Submerged Micron-Sized Double-Orifice Plates: Experiments and Modeling

Numerical Investigation on Coalescence Behavior of Liquid Inclusion Particles in Argon Bubble Wake Flow

Bubble Dynamics and Mass Transfer Characteristics from an Immersed Orifice Plate

Effect of Orifice Geometry on Bubble Formation in Melt Gas Injection to Prepare Aluminum Foams

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Experimental and Numerical Study on the Formation and Detachment of Bubbles at Orifices under the Impinging Jet Flow

A Computational Study of Bubble Formation from an Orifice Submerged in Liquid with Constant Gas Flow

Role of Bubble Dynamics in Heat and Mass Transfer in Annular Flows

Experimental Study of Bubble Formation Process on the Micro-Orifice in Mini Channels

Flowrate Effects on the Lateral Coalescence of Two Growing Bubbles

Effect of Contact Angle on Bubble Formation at Submerged Orifices

Analyses of Bubble Dynamics in Subcooled Boiling Flow Using Euler-Lagrange Method