Abstract:The present work consisted in developing a computational routine for prediction and characterization ignition delay time, pressure, temperature generated and energy released in the combustion process in a shock tube. Mathematical modeling considered the high-pressure region of the shock tube known as the conducted section. The Lazarus code compiler was used to generate the unstructured triangular meshes and to implement the computational routines to simulate the propagation of shock waves inside the shock tube. The mathematical modeling used the geometric parameters of the shock tube of the combustion laboratory of the Federal University of Minas Gerais and was based only on the displacement of the shock wave after the diaphragm rupture. The main objective of the work was the development of computational routines to characterize the shock wave parameters of the ignition delay times of conventional diesel to validate the experimental tests carried out in the shock tube conducted by Santana et al. [3] and compare it with the experimental tests and numerical simulations carried out by other authors available in the literature. A linear regression of the experimental tests conducted by Santana et al. [3] with conventional diesel was performed to obtain the Arrhenius equation for numerical simulation of the ignition delay time of diesel under the following conditions: temperatures from 880 to 1300 K, pressures 24 bar and equivalence ratio 1. The results show good prediction between experimental tests and numerical simulations. Were found delay times ranging from 425 to 1890 μs. Considering all temperature range, the difference between the experimental and simulated test was approximately 15%, this difference also can be explained by the measurement in the shock tube, that the ignition delay time was calculated by the time difference between the passage of the shock wave by the pressure sensor and the start of the ignition detected by the luminosity detection sensor. This work is relevant because it was developed computational routine in open software and the results achieved in the simulation were considered satisfactory, since they are in the same order of magnitude as the results found in the experimental tests carried out by Santana et al. [3] and other works.

A simple, self-sufficient approach for the design of shock tube driver insert

The Use of Driver Inserts to Reduce Non-Ideal Pressure Variations Behind Reflected Shock Waves

An optimal study on a TVC evaporation tube using moving particle semi-implicit method

Numerical Investigation on Critical Ignition in Shock Tube with Controlled Expansion Rate

Application of H2 and CO2 Addition in Driver Section on Shock Tube Ignition Delay Measurement

Contact Surface Tailoring Condition for Shock Tubes with Different Driver and Driven Section Diameters

Predicting Non-Ideal Effects from the Diaphragm Opening Process in Shock Tubes

European Shock-Tube for High-Enthalpy Research Combustion Driver Qualification

Constrained Reaction Volume: A New Approach to Studying Reactive Systems in Shock Tubes

UNSTEADY CHARACTERISTICS OF THE SHOCK PROPAGATION IN A CONVERGENT SHOCK TUBE WITH SMALL ANGLE

Information-Driven Design for Shock Tube / Laser Absorption Studies of Fundamental Rate Constants in Combustion, with Application to Methanol Pyrolysis

Shock tube ignition delay time measurements in propane/O2/argon mixtures at near-constant-volume conditions

Numerical modeling of a high-enthalpy shock tunnel driven by gaseous detonation

Realization of a shock-tube facility to study the Richtmyer-Meshkov instability driven by a strong shock wave

Shock Tube Design for High Intensity Blast Waves for Laboratory Testing of Armor and Combat Materiel

Experimental Study on Pressure Dynamics and Self-Ignition of Pressurized Hydrogen Flowing into the L-shaped Tubes

Analysis of the Overpressure Fields in a Shock Tube with Multi-Point Initiation

Experimental analysis and numerical simulation of ignition delay time of diesel fuel using a shock tube

Blast load simulation using conical shock tube systems

Non-uniform Ignition Behind a Reflected Shock and Its Influence on Ignition Delay Measured in a Shock Tube

Numerical Simulation and Measurements of Reaction Load for an Impulsively Loaded Pressure Vessel