Abstract:The bending vibration modes of asymmetric magnetoelectric (ME) laminated composites operate in a low-frequency range, but the small value of the ME voltage coefficient (alpha(ME)) at bending vibration frequencies currently hinders the application of ME magnetic sensors at lower frequencies. In this study, poly(vinylidene fluoride) (PVDF) and Metglas were combined by adhesive bonding method to manufacture laminated ME composites. The average stiffness of ME composites was reduced by using vacuum packing technique to modulate the dominant vibration mode from longitudinal to bending. After treatment, the dominant resonance frequency and the DC bias field of the samples with a length of 30 mm were reduced from 51.15 kHz and 3.7 Oe to 10.59 kHz and 2.35 Oe, respectively. The alpha(ME) of the samples was significantly increased to 493.7 Vcm(-1)Oe(-1), which is approximately 2.5 times higher than that of the untreated samples. Remarkable magnetic sensing capabilities at low frequencies of the treated samples were also were found. At 10.59 kHz, the samples had a large sensitivity of 2522.33 mVOe(-1), an excellent linearity of 0.99985, and good resolutions of 0.4 nT for AC and 2.4 nT for DC magnetic fields, respectively. In addition, samples of different sizes were prepared for comparison. The experimental results obtained from these samples were consistent with those of the original samples. These findings highlight the effectiveness of reducing the average stiffness of composites through the vacuum packing technique in reducing the resonance frequency, optimizing the bias field, and increasing the alpha(ME) value. This technique provides a valuable approach to the development of low-frequency and highly sensitive magnetic field sensors.

Low-Frequency and High-Sensitivity PVDF/Metglas Magnetoelectric Sensor Based on Bending Vibration Mode

Magnetostrictive Strain Monitoring of Cement-Based Magnetoelectric Composites in A Variable Magnetic Field by Fiber Bragg Grating

Evaluation of Metglas/polyvinylidene Fluoride Magnetoelectric Bilayer Composites for Flexible In-Plane Resonant Magnetic Sensors

Enhanced Performance of Weak Magnetic Field Sensor Based on Laminated Cantilever: Theoretical Analysis and Experimental Verification

Flexible Magnetoelectric Transducer with High Magnetic Field Sensitivity Based on Metglas/poly(vinylidene Fluoride) Heterostructures

Self-biased Metglas/PVDF/Ni magnetoelectric laminate for AC magnetic sensors with a wide frequency range

Giant zero-biased flexible magnetoelectric laminate composites for wearable magnetic sensor

High-sensitivity Laminated Magnetoelectric Sensors Without Bias in Composite of Positive/negative Giant Magnetostrictive Materials and Piezoelectric Single Crystals

Micro-Sensors with Giant magnetoelectric Coefficient

Ultrasensitive flexible magnetoelectric sensor

High Sensitive Nonlinear Modulation Magnetoelectric Magnetic Sensors with a Magnetostrictive Metglas Structure Based on Bell-Shaped Geometry

Self-biased magnetoelectric sensor operating in d 36 face-shear mode

Low-Frequency Magnetic Field Detection Using Magnetoelectric Sensor With Optimized Metglas Layers by Frequency Modulation

Enhanced Self-Bias Magnetoelectric Effect in Locally Heat-Treated ME Laminated Composite

Magnetoelectric bending-mode structure based on Metglas/Pb(Zr,Ti)O 3 fiber laminates

Self-Biased Magnetoelectric Sensor Operating in <i>d</i><sub>36</sub> Face-Shear Mode

Self-Biased Magnetoelectric Sensor Operating in <italic>d</italic><sub>36</sub> Face-Shear Mode

Magnetoelectric bending-mode structure based on Metglas/Pb(Zr,Ti)O₃ fiber laminates.

Wide-bandwidth High-Sensitivity Magnetoelectric Effect of Magnetostrictive/piezoelectric Composites under Adjustable Bias Voltage

Significant improving magnetoelectric sensors performance based on optimized magnetoelectric composites via heat treatment

Enhanced Dc Magnetic Field Sensitivity by Improved Flux Concentration in Magnetoelectric Laminates