Optimization of Chanterelle Mushroom Drying Kinetics under Heat Pump Dryer Using Taguchi Design Method

Peter Mecha,Rui Zhu,Jiayu Zhang,Emmanuel Awuah,Shakeel Ahmed Soomro,Kunjie Chen
DOI: https://doi.org/10.25165/j.ijabe.20231606.6408
2023-01-01
International Journal of Agricultural and Biological Engineering
Abstract:The optimum drying conditions with regard to minimum color changes, high rehydration ratio and drying rate for chanterelle mushrooms is inadequately known. To address this problem, drying kinetics for chanterelle mushroom samples with sizes of 20 mmx20 mmx20 mm cube, 20 mmx20 mmx30 mm cuboid, and o40 mmx20 mm cylindrical shape were experimented. Drying air temperatures of 40 degrees C, 48 degrees C, and 56 degrees C at superfluous humidity and velocity of 2.2 m/s were used. Initial color pixels for each sample were determined using Note 8 Pro Xiaomi smartphone camera and image processing tool in Matlab R2019a. Triplicate experimentation was done based on L9 Taguchi orthogonal arrays with drying rate, specific moisture extraction rate, color change, and rehydration ratio being the response parameters. The drying rate increased from 1.1174 g/g center dot min to 1.3478 g/g.min as the temperature rose from 40 degrees C to 56 degrees C. The mushroom cube had the highest drying rate of 1.2860 g/g center dot min while the cylindrical shape had the lowest rate of 1.1764 g/g center dot min. Similarly, SMER increased from 0.006 326to 0.013 27 g/kWh with the temperature rise. Contrary, SMER decreased from 0.006 92 to 0.013 63 g/kWh in cylinder to cube respectively. Color change was highest at 40 degrees C (13.49) and lowest at 56 degrees C (11.94). The mushroom cube had the lowest color change of 9.28 on average when compared to other shapes. Rehydration ratio was highest at 56 degrees C (3.824) as compared to 48 degrees C and 40 degrees C. Additionally, the mushroom cube had the highest rehydration ratio of 4.55 on average as compared to other shapes. Temperature variation significantly influenced the drying rate and SMER. However, temperature variation had insignificant differences in color change and rehydration ratio. Mushroom shape variation had a significant difference in all the response variables tested. Conclusively, mushroom cubes at the drying temperature of 56 degrees C gave optimized drying conditions for chanterelle mushrooms with minimal quality deviations. Thus, chanterelle mushrooms can be sliced into cubes to allow quick drying rate, better SMER, rehydration ratio, and have minimal color change.
What problem does this paper attempt to address?