Abstract:The National Synchrotron Radiation Laboratory is planning to build a 2.2 GeV diffraction-limited storage ring, the Hefei Advanced Light Facility (HALF), with a 6BA lattice structure and a large number of longitudinal gradient bends (LGBs). In order to increase the radiated photon energy to the hard X-ray band and to reduce the natural emittance, a superconducting longitudinal gradient bend (SLGB) magnet is planned to be used on HALF in the future, which requires a magnetic field integral of 0.40 T center dot m over a length of 0.46 m and a peak field of about 5 T. A SLGB has many structural parameters, such as the geometric parameters of the superconducting coils and the thickness of the yoke, etc. Their influence on the magnetic field distribution has been studied, although the computation of the 3D magnet model is very slow. Considering the longitudinal field variation, the vertical gap limitation, the field homogeneity requirement and the critical current of the superconducting wire, a method is developed to simplify the 3D magnet simulation by a corresponding 2D model, so that the longitudinal magnetic field profile of a 3D model can be approximately calculated in a 2D model with faster speed. Due to the faster calculation speed of 2D models, a Mathematica-based optimization program is developed and relatively good structural parameters for the HALF SLGB are found by the program. The simulation results show that the physical design requirements can be well met. The electromagnetic design for the HALF SLGB magnet is based on the current ???? level of NbTi superconductor due to its excellent mechanical performance.

Design of A Permanent Quadrupole Magnet with Adjustable Magnetic Field Gradient

Permanent-magnet Quadrupoles for an Interdigital H-mode Drift Tube Linear Accelerator: Optimization Code and Adjustable Magnet Design

Design of permanent magnet for the nuclear magnetic resonance tool

Development of a Novel High Gradient Quadrupole Magnet

Status of Multipole Magnets for Hefei Advanced Light Facility

Design Study of Combined Magnet with Combined Function Method

Design and Optimization of Combined-Function Quadrupole-Sextupole Magnets

Design Methods of the Spherical Quadrupole Magnets and Sextupole Magnets

The Magnet Design for the HLS Storage Ring Upgrade Project

Enhance the Field Strength by Adding Soft Iron in the Hybrid Permanent magnet

Electromagnetic design study of a superconducting longitudinal gradient bend magnet based on the HALF storage ring

Design of the Magnets of the HALS Project

Development of short prototype of dual aperture quadrupole magnet for CEPC ring

Variable high gradient permanent magnet quadrupole (QUAPEVA)

Permanent Magnet System for MRI with Constant Gradient mechanically adjustable in Direction and Strength

Design of Prototype Magnets for HUST Proton Therapy Beamline

Optimum Design Method of the Modified Quadrupole Magnet for the Magnetic StereoTaxis System

Design and Test of a Half-Aperture Canted-Cosine-Theta Multipole Prototype Magnet for the HIAF FRagment Separator

Optimization design of a permanent magnet used for a low field (0.2 T) movable MRI system

2-D Mechanical Design Study of A 20-T Two-In-One Common-Coil Dipole Magnet for High-Energy Accelerators

Magnetic Field Optimization of a Novel Hybrid Permanent Undulator