Abstract:A system for electromagnetic measurements was designed and installed on the Keda Torus eXperiment (KTX) reversed field pinch device last year. Although the unique double-C structure of the KTX, which allows the machine to be opened easily without disassembling the poloidal field windings, makes the convenient replacement and modification of the internal inductive coils possible, it can present difficulties in the design of flux coils and magnetic probes at the two vertical gaps. Moreover, the KTX has a composite shell consisting of a 6 mm stainless steel vacuum chamber and a 1.5 mm copper shell, which results in limited space for the installation of saddle sensors. Therefore, the double-C structure and composite shell should be considered, especially during the design and installation of the electromagnetic diagnostic system (EDS). The inner surface of the vacuum vessel includes two types of probes. One type is for the measurement of the global plasma parameters, and the other type is for studying the local behavior of the plasma and operating the new saddle coils. In addition, the probes on the outer surface of the composite shell are used for measurements of eddy currents. Finally, saddle sensors for radial field measurements for feedback control were installed between the conducting shell and the vacuum vessel. The entire system includes approximately 1100 magnetic probes, 14 flux coils, 4×26×2 saddle sensors, and 16 Rogowski coils. Considering the large number of probes and limited space available in the vacuum vessel, the miniaturization of the probes and optimization of the probe distribution are necessary. In addition, accurate calibration and careful mounting of the probes are also required. The frequency response of the designed magnetic probes is up to 200 kHz, and the resolution is 1 G. The EDS, being spherical and of high precision, is one of the most basic and effective diagnostic tools of the KTX and meets the demands imposed by requirements on basic machine operating information and future studies.

Cascade Internal Model Control Scheme for Pid Feedback Control on Keda Tours Experiment

Research on Cascade Control Strategy for Thermal Management System of Giant Magnetostrictive Actuator

Real-time MHD feedback control system in Keda Torus eXperiment

Internal Model Control of Internal Thermally Coupled Air Separation Column

Multi-loop Internal Model Controller Design Based on a Dynamic PLS Framework

Improved 2-Order Active Disturbance Rejection Control for PMSM

Research on PID Tuning Method of Magnetically Suspended Rotor System Based on IMC

Expert-PID Synchronization Control of Thrust Hydraulic System

Adaptive Model Predictive Control Scheme for Partially Internal Thermally Coupled Air Separation Column

Error Field Feedback Control System in the Keda Torus Experiment and Open Loop Control Experiment

The Design of the Plasma Control System in Ktx

The Electronics Design of Error Field Feedback Control System in KTX

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Real-time data processing method for the feedback control system of the error field of the Keda Torus eXperiment around the gap

Electromagnetic Diagnostic System for the Keda Torus Experiment

Research on a Novel PID Based Controller for Nonmagnetic Hydraulic Navigation Simulator with AMESim Simulation

Design of a Feedback Control System for Keda Torus Experiment Equilibrium Field Power Supply

Simulation and Design of Feedback Control on Resistive Wall Modes in Keda Torus Experiment

Design of Magnetic Bearing Control System Based on Active Disturbance Rejection Theory

Multivariable Multi-Model-Based Magnetic Control System for the Current Ramp-Up Phase in the National Spherical Torus Experiment (Nstx)

Coupling Circuit Model and Discharge Waveform Prediction for Keda Torus Experiment