Abstract:When a pump operates in part-load conditions, it is apt to form flow separations and even stall cells at the blade surfaces. In some conditions, stall cells may circumferentially propagate among the blade channels, known as rotating stall, which can affect the rotor system dynamic stability. Conventionally it is believed that the formation and circumferential propagation of stall cells is attributed to the nonuniformity of the flow state in front of the impeller inlet. In recent decades, many investigations indicate that the uneven flow field at the impeller outlet related to the asymmetric volute casing is also an important factor to induce rotating stalls. Thus the formation and propagation mechanism of rotating stalls is complex and has not been clearly understood so far. In addition, previous studies mainly focused on the rotating stalls in vaned diffusers, while it is more difficult to figure out rotating stalls in impellers for which little studies has been done. In this paper, numerical simulations are conducted for a three-blade centrifugal pump with a flow rate of 0.75Qd where Qd is the design flow rate. The SST-SAS model with a curvature correction is applied to predict the unsteady internal flows. The time-averaged pump head, efficiency and axial power agree well with the experimental results from a previous test. From the numerical results, a special rotating stall is detected in this condition. In order to verify the effect of the volute casing, a contrast simulation is also conducted without the volute casing domain. It shows that rotating stalls always occur whether there is a volute casing or not, but the distribution and motion of the stall cells are changed by the existence of the volute casing. It indicates that the nonuniform flow distribution at the impeller outlet is not an essential factor for the formation of rotating stall but accelerates the variation of stall cells. Based on the whole-flow-passage result, a stall cell in one blade channel disappears for about 2/15T (T is the duration of one revolution) when the downstream blade runs across the tongue, and the same phenomenon recurs in the upstream blade channel after 1/3T, which is unusual and worthy of investigation. The pressure fluctuations within the whole flow passage are intensified by the rotating stall more or less, especially at the middle region of pressure surface of blades, around the tongue and in the beginning of the discharge passage.

Spatiotemporal Characteristics of Rotating Stall in a Centrifugal Compressor with a Volute at Low-Flow Rate Conditions

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Effects of Nonaxisymmetric Volute on Rotating Stall in the Vaneless Diffuser of Centrifugal Compressors

Evolution of Unsteady Vortex Structures and Rotating Stall Cells in a Centrifugal Compressor with Vaneless Diffuser

Numerical Investigation on the Rotating Stall Characteristics in A Three-Blade Centrifugal Impeller

Unsteady Flow and Pressure Pulsation Characteristics Analysis of Rotating Stall in Centrifugal Pumps Under Off-Design Conditions

Study of Rotating Stall in a Centrifugal Compressor with Wide Vaneless Diffuser

A Review of Rotating Stall in Vaneless Diffuser of Centrifugal Compressor

Stall Evolution Mechanism of a Centrifugal Compressor with a Wide-Long Vaneless Diffuser

Dynamic evolution process of rotating stall vortex based on high-frequency PIV system in centrifugal impeller

The role of radial secondary flow in the process of rotating stall for a 1.5-stage axial compressor

Stall Mode Transformation in the Wide Vaneless Diffuser of Centrifugal Compressors

Experimental Investigation on the Aerodynamic Instability Process of a High-Speed Axial-Centrifugal Compressor

Study on the vibration characteristics induced by rotating stall in a centrifugal pump based on improved variational mode decomposition

Unsteady near-stall flow mechanisms in a transonic compressor rotor at different rotating speeds

Spatiotemporal Evolution and Fluctuation Characteristics of a Centrifugal Compressor under Near-Stall Conditions and High Mass-Flow Rate

Investigating Three-Dimensional Vortex Evolution in Centrifugal Pump under Rotating Stall Conditions Using Tomographic Particle Image Velocimetry

Unsteady Flow Characteristics of Rotating Stall and Surging in a Backward Centrifugal Fan at Low Flow-Rate Conditions

Investigation of tip leakage flow unsteadiness and rotating instability in a centrifugal compressor impeller

Numerical investigation of the unsteady tip leakage flow and rotating stall inception in a transonic compressor

Effects of rotating inlet distortion on the stall mechanism of an axial flow compressor