Abstract:When a pump operates in part-load conditions, it is apt to form flow separations and even stall cells at the blade surfaces. In some conditions, stall cells may circumferentially propagate among the blade channels, known as rotating stall, which can affect the rotor system dynamic stability. Conventionally it is believed that the formation and circumferential propagation of stall cells is attributed to the nonuniformity of the flow state in front of the impeller inlet. In recent decades, many investigations indicate that the uneven flow field at the impeller outlet related to the asymmetric volute casing is also an important factor to induce rotating stalls. Thus the formation and propagation mechanism of rotating stalls is complex and has not been clearly understood so far. In addition, previous studies mainly focused on the rotating stalls in vaned diffusers, while it is more difficult to figure out rotating stalls in impellers for which little studies has been done. In this paper, numerical simulations are conducted for a three-blade centrifugal pump with a flow rate of 0.75Qd where Qd is the design flow rate. The SST-SAS model with a curvature correction is applied to predict the unsteady internal flows. The time-averaged pump head, efficiency and axial power agree well with the experimental results from a previous test. From the numerical results, a special rotating stall is detected in this condition. In order to verify the effect of the volute casing, a contrast simulation is also conducted without the volute casing domain. It shows that rotating stalls always occur whether there is a volute casing or not, but the distribution and motion of the stall cells are changed by the existence of the volute casing. It indicates that the nonuniform flow distribution at the impeller outlet is not an essential factor for the formation of rotating stall but accelerates the variation of stall cells. Based on the whole-flow-passage result, a stall cell in one blade channel disappears for about 2/15T (T is the duration of one revolution) when the downstream blade runs across the tongue, and the same phenomenon recurs in the upstream blade channel after 1/3T, which is unusual and worthy of investigation. The pressure fluctuations within the whole flow passage are intensified by the rotating stall more or less, especially at the middle region of pressure surface of blades, around the tongue and in the beginning of the discharge passage.

Unsteady Flow Characteristics of Rotating Stall and Surging in a Backward Centrifugal Fan at Low Flow-Rate Conditions

Numerical simulation of internal flow in forward-curved centrifugal fan

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Unsteady Flow and Pressure Pulsation Characteristics Analysis of Rotating Stall in Centrifugal Pumps Under Off-Design Conditions

Evolution of Unsteady Vortex Structures and Rotating Stall Cells in a Centrifugal Compressor with Vaneless Diffuser

Investigating the unsteady flow mechanism at the lip of a ducted fan in crosswind

High-frequency unsteady flow near the tip in a transonic fan rotor with a small clearance

Unsteady flow structures in the tip region for a centrifugal compressor impeller before rotating stall

Numerical Investigation on the Rotating Stall Characteristics in A Three-Blade Centrifugal Impeller

Unsteady near-stall flow mechanisms in a transonic compressor rotor at different rotating speeds

Investigation of the Instability Mechanisms in a Turbocharger Centrifugal Compressor with a Vaneless Diffuser by Means of Unsteady Simulations

Numerical simulation on role of the rotating stall on the hump characteristic in a mixed fl ow pump using modi fi ed partially averaged Navier-Stokes model

Asymmetric flow in a double-suction centrifugal fan induced by an inclined impeller

Influence Mechanism of Ambient Air Parameters on the Rotational Stall of an Axial Fan

Effects of Nonaxisymmetric Volute on Rotating Stall in the Vaneless Diffuser of Centrifugal Compressors

INVESTIGATION ON THE UNSTEADY SURGE FLOW BEHAVIOR OF AN AXIAL-CENTRIFUGAL COMPRESSOR

Spatiotemporal Evolution and Fluctuation Characteristics of a Centrifugal Compressor under Near-Stall Conditions and High Mass-Flow Rate

Numerical investigation of the unsteady tip leakage flow and rotating stall inception in a transonic compressor

Investigation of Flow Instability Characteristics in a Low Specific Speed Centrifugal Pump Using a Modified Partially Averaged Navier–Stokes Model

Dynamic evolution process of rotating stall vortex based on high-frequency PIV system in centrifugal impeller

Experimental and computational investigation on flow characteristics of rotating cavities with high inlet pre-swirl axial throughflow