Abstract:The laser hot-wire (LHW) process has the potential to deposit material at high rates using low laser power. An LHW experiment was designed to be able to deposit material at the rate of 3.46 kg per hour with less than 10 kW of laser power. Four thermocouples were built into the substrate to record the temperature variation during the deposition. The results show that temperature fluctuates in a periodic manner with the deposition layer by layer. Simultaneously, the distortion of the substrate was measured. The substrate is distorted, and the maximum distortion increases gradually during deposition.The equivalent heat conduction coefficient for heat convection in the molten pool is discussed. It becomes apparent that the heat convection of flowing molten metal is 3-5 times that of molten metal at rest. The absorptivity of laser power was determined by comparison between the simulation and a one-pass cladding experiment. The absorptivity of laser power is approximately 15% in this experiment.Numerical simulation of LHW additive manufacturing was conducted to obtain the temperature, stress and strain fields, and the distortion. The outstanding features for numerical simulation are additive geometry and numerous analysis steps. The INP files of ABAQUS are compiled in a Matlab program because of the considerable number of steps and element definitions. Temperature variation and substrate distortion are both measured to validate the FEA model. The verification result indicates that the LHW model is feasible and accurate.The maximum residual stress is located in the junction between the deposit and substrate when the deposition is finished. This junction area becomes the most likely crack position. Deposited material undergoes complicated thermal cycles during the LHW process. Temperature variation determines the phase transformation. The microstructure change of the heat affected zone was analyzed on the basis of computational temperature variation. Such interpretation can effectively explain softened area in the heat affected zone of the substrate. A numerical computation method is used to map the processing window of stable hot-wire deposition. It is shown that the stable deposition has top and bottom limitations under a certain current intensity and wire feed speed. (C) 2016 Elsevier B.V. All rights reserved.

Temperature Field Simulation and Experiment of Sliding-Pressure Additive Manufacturing Based on Joule Heat

Study on the Process Characteristics Based on Joule Heat of Sliding-Pressure Additive Manufacturing

Heat Transfer to the Wire Based on Multiphysics Model for Wire Arc Additive Manufacturing

Effect of Induction Heat Treatment on Residual Stress Distribution of Components Fabricated by Wire Arc Additive Manufacturing

Numerical simulation of thermal and stress fields for multilayer and multi-pass weaving WAAM of magnesium alloy

Numerical Analysis and Experimental Verification of Resistance Additive Manufacturing

Heat and Mass Transfer in Electron Beam Additive Manufacturing

Investigation of the thermal behavior during the direct writing metal additive manufacturing

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Finite Element Analysis of Thermal Stress and Thermal Deformation in Typical Part during SLM

Numerical Study of Heat Transfer Characteristics in Positional Wire and Arc Additive Manufacturing

A computationally efficient thermo-mechanical model for wire arc additive manufacturing

Study on Single-Layer and Single-Channel Microstructure of 304 Stainless Steel Using Joule Heat Additive Manufacturing

Modeling and Experimental Study on a New Electric-thermal Heating Method for Shape Memory Alloy Wire Actuators

Experimental Study and Modeling of H13 Steel Deposition Using Laser Hot-Wire Additive Manufacturing

Numerical Simulation of Residual Stress and Deformation in Wire Arc Additive Manufacturing

Thermal simulation of wire arc additive manufacturing: a new material deposition and heat input modelling

Numerical simulation for microstructure control in wire arc additive manufacturing of thin-walled structures

Numerical prediction of Joule heating effect in electric hot incremental sheet forming

Thermo-mechanical analysis of Wire and Arc Additive Layer Manufacturing process on large multi-layer parts