Abstract:This graphical abstract presents a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B architecture, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage, an OTA‐based RC integrator with anti‐aliasing properties, is chopped to mitigate offset and 1/f noise, while the second stage employs a switched‐capacitor integrator with OTA‐sharing to reduce complexity and enable signal addition before quantization. Fabricated in a 180‐nm CMOS process, the DSM achieves a 103 dB dynamic range in a 100 Hz bandwidth, with peak SNDR, SNR, and SFDR values of 95.8 dB, 97.1 dB, and 102.8 dB, respectively, and consumes 10.7 μ A from a 1.8 V supply. The Schreier figure‐of‐merit (FoMs) is 170.2 dB, highlighting its energy efficiency. This paper reports a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B topology, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage is an OTA‐based RC integrator with inherent anti‐aliasing properties, while the second stage is a switched‐capacitor integrator. Offset and 1/f noise in the first stage are mitigated by the chopper‐stabilization technique, while those in the second stage are suppressed through the gain provided by the first stage. Furthermore, the OTA‐sharing technology is utilized in the second stage to realize signal addition before quantization, reducing design complexity. The hybrid DSM prototype is fabricated with a 180‐nm CMOS process and occupies an area of 0.123 mm2. Measurement results show peak SNDR/SNR/SFDR values of 95.8, 97.1, and 102.8 dB, respectively, with a current consumption of 10.7 μ A from a 1.8‐V single supply. The reported DSM achieves a 103‐dB dynamic range in a 100‐Hz signal bandwidth, corresponding to a Schreier figure‐of‐merit (FoMs) value of 170.2 dB.

An Energy-Efficient Discrete-Time Delta–Sigma Modulator with Dynamic-Range Enhancement and Tri-Level CDAC

A 1.2 V 2.3 Μw 94.7 Db DR Delta-Sigma Modulator with Dynamic-Range Enhancement and Tri-Level CDAC

A 10.7-Μa 103-Db DR Hybrid Delta-Sigma Modulator for Sensing Applications

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

Low-power High-Linearity Sigma-Delta Modulator for Audio Applications

An 18-Bit High Performance Audio Sigma-Delta D/A Converter

A Σδ Modulator Using Gain-Boost Class-C Inverter for Audio Applications.

A 0.18 Μm High Resolution Bandpass Delta-Sigma Modulator for Acceleration Transducer Applications

A 200 Khz Bandwidth Ea Dac With A Spur Free Modulator

An Audio Cascaded Sigma Delta Modulator Using Gain-Boost Class-C Inverter

A 10.7‐μ A 103‐dB DR Hybrid Delta‐Sigma Modulator for Sensing Applications

An 88 dB SNDR 100 kHz BW Sturdy MASH Delta-Sigma Modulator Using Self-Cascoded Floating Inverter Amplifiers

A 10-Khz BW 104.3-Db DR Discrete-Time Delta-Sigma Modulator with Ring-Amplifier-based Integrator

Low‐power multibit delta–sigma modulator based on passive and unattenuated summation scheme

A Partially Feedback NSSAR Embedded Third-Order Delta–Sigma Modulator with Gain-Boosted Two-Stage FIAs

A 20 Mu W 95db Dr Single-Bit Delta-Sigma Modulator for Portable Measurement Applications

A 6 $\mu$ W 95 Db SNDR Inverter Based $\sigma\delta$ Modulator with Subtractive Dithering and SAR Quantizer

A 0.8-V 230-$\mu$ W 98-dB DR Inverter-Based $\Sigma \Delta$ Modulator for Audio Applications.

A 172.5Db-Fom Hybrid CT/DT Incremental Σ∆Modulator for Direct Current-to-Digital Conversion

A 6 μW 95 dB SNDR Inverter Based ΣΔ Modulator with Subtractive Dithering and SAR Quantizer

A Low Power Sigma-Delta Modulator with Hybrid Architecture