Abstract:About 9 wt.% Cr steels are widely used in the design and fabrication of thick section components in combined cycle or coal-fired applications for working temperatures of 600 ~ 650°C. This family of materials possesses a martensitic microstructure stabilised by precipitates. The presence of nitrides, inclusions or evolution of second-phase particles may increase the metallurgical risk to creep. The chemical composition and microstructural evolution of 9 wt.% Cr steels contribute to thermal stability and long-term performance. In some specialist alloys, Ta is added to the composition which causes the formation of fine MX precipitates which are only present at the nanometre scale in tempered martensite, which hinders the recovery of dislocations and the migration of laths to extend creep life. However, the presence of large Ta-containing particles or inclusions in the 9 wt.% Cr steels may have a detrimental effect on its creep performance, as they may act as preferred sites for cavity nucleation. To fully appreciate the development of damage in these steels, it is necessary to link the pre- and post-test conditions, evaluate damage in the parent metal, develop procedures that provide consistency of results, and obtain statistically relevant data. The evolution of the Ta-containing phase has been tracked and quantified using a variety of correlative characterisation approaches. Utilising focused ion beam microscopy and two-dimensional electron-based microscopic characterisation, three-dimensional tomography has identified a strong relationship between creep cavities and Ta-containing phases from the early stages of creep.

Enhanced Disperse Ta(C, N) Precipitation in Reduced Activation Ferritic/martensitic Steels by Optimized Two-Step Austenitizing

Strain-induced Refinement and Thermal Stability of a Nanocrystalline Steel Produced by Surface Mechanical Attritiontreatment

Developing of containing Ta, Zr reduced activation ferritic/martensitic (RAFM) steel with excellent creep property

Effect of Ta and Ti on Modified Reduced Activation Ferritic/Martensitic Steels with a Thermo‐mechanical Control Process

Improving High Temperature Creep Resistance of Reduced Activation Steels by Addition of Nitrogen and Intermediate Heat Treatment

Effect of TaC Particles Dissolution on Grain Coarsening in Reduced Activation Steels

Investigation on Precipitation Behaviors of MX Phase in Reduced Activation Steels

Design of Reduced Activation Ferritic/Martensitic Steels by Multiphase Optimization During the Entire Processing

Control of Precipitation Behavior in Reduced Activation Steels by Intermediate Heat Treatment

Microstructure and mechanical properties of a nanoscale-precipitate-strengthened reduced-activation refractory complex concentrated alloy

Multiphase precipitation and its strengthening mechanism in a V-containing austenite-based low density steel

Influence of austenitizing temperature on the mechanical properties and microstructure of reduced activation ferritic/martensitic steel

Tailoring the metastable reversed austenite from metastable Mn-rich carbides

Regulation of Cu Precipitation by Intercritical Tempering in A Hsla Steel

TaC Precipitation Behaviors in Reduced Activation Martensitic Steels

Effect of Austenitization Conditions on the Transformation Behavior of Low Carbon Steel Containing Ti⁻Ca Oxide Particles

Nanocrystallization of a Quenched RAFM Steel and Microstructure Evolution During Annealing Heat Treatment

A Novel Additive Manufactured Reduced Activation Ferritic/martensitic Steel Enhanced by In-Situ Nanoparticles Benefiting from Oxygen Addition

Precipitate Phases in an 11% Cr Ferritic/Martensitic Steel with Tempering and Creep Conditions

Enhanced High‐Temperature Strength of a Low‐Density Dispersion‐Strengthened Fe–Mn–Al–C Steel

Evaluation of metallurgical risk factors in post-test, advanced 9% Cr creep strength enhanced ferritic (CSEF) steel