Abstract:The effective radiative forcing of anthropogenic aerosols (ERFaer) is an important measure of the anthropogenic aerosol effects simulated by a global climate model. Here we analyze ERFaer simulated by the E3SM version 1 (E3SMv1) atmospheric model using both century-long free-running atmosphere–land simulations and short nudged simulations. We relate the simulated ERFaer to characteristics of the aerosol composition and optical properties, and we evaluate the relationships between key aerosol and cloud properties. In terms of historical changes from the year 1870 to 2014, our results show that the global mean anthropogenic aerosol burden and optical depth increase during the simulation period as expected, but the regional averages show large differences in the temporal evolution. The largest regional differences are found in the emission-induced evolution of the burden and optical depth of the sulfate aerosol: a strong decreasing trend is seen in the Northern Hemisphere high-latitude region after around 1970, while a continued increase is simulated in the tropics. The relationships between key aerosol and cloud properties (relative changes between pre-industrial and present-day conditions) also show evident changes after 1970, diverging from the linear relationships exhibited for the period of 1870–1969. In addition to the regional differences in the simulated relationships, a reduced sensitivity in cloud droplet number and other cloud properties to aerosol perturbations is seen when the aerosol perturbation is large. Consequently, the global annual mean ERFaer magnitude does not increase after around 1970. The ERFaer in E3SMv1 is relatively large compared to the recently published multi-model estimates; the primary reason is the large indirect aerosol effect (i.e., through aerosol–cloud interactions). Compared to other models, E3SMv1 features large relative changes in the cloud droplet effective radius in response to aerosol perturbations. Large sensitivity is also seen in the liquid cloud optical depth, which is determined by changes in both the effective radius and liquid water path. Aerosol-induced changes in liquid and ice cloud properties in E3SMv1 are found to have a strong correlation, as the evolution of anthropogenic sulfate aerosols affects both the liquid cloud formation and the homogeneous ice nucleation in cirrus clouds (that causes a large effect on longwave ERFaer). As suggested by a previous study, the large ERFaer appears to be one of the reasons why the model cannot reproduce the observed global mean temperature evolution in the second half of the 20th century. Sensitivity simulations are performed to understand which parameterization and/or parameter changes have a large impact on the simulated ERFaer. The ERFaer estimates in E3SMv1 for the shortwave and longwave components are sensitive to the parameterization changes in both liquid and ice cloud processes. When the parameterization of ice cloud processes is modified, the top-of-model forcing changes in the shortwave and longwave components largely offset each other, so the net effect is negligible. This suggests that, to reduce the magnitude of the net ERFaer, it would be more effective to reduce the anthropogenic aerosol effect through liquid or mixed-phase clouds.

Supplementary Material to &quot;surprising Similarities in Model and Observational Aerosol Radiative Forcing Estimates&quot;

Surprising Similarities in Model and Observational Aerosol Radiative Forcing Estimates

Why Must a Solar Forcing Be Larger Than a CO 2 Forcing to Cause the Same Global Mean Surface Temperature Change?

Scenario Setup and Forcing Data for Impact Model Evaluation and Impact Attribution Within the Third Round of the Inter-Sectoral Impact Model Intercomparison Project (Isimip3a)

Comparison of particle number size distribution trends in ground measurements and climate models

Uncertainties in Global Aerosol Simulations: Assessment Using Three Meteorological Data Sets

Intercomparison and Evaluation of Global Aerosol Microphysical Properties among AeroCom Models of a Range of Complexity

LongRunMIP: Motivation and Design for a Large Collection of Millennial-Length AOGCM Simulations

Challenges In Constraining Anthropogenic Aerosol Effects On Cloud Radiative Forcing Using Present-Day Spatiotemporal Variability (Vol 113, Pg 5804, 2016)

Using historical temperature to constrain the climate sensitivity, the transient climate response, and aerosol-induced cooling

Effective radiative forcing of anthropogenic aerosols in E3SMv1: historical changes, causality, decomposition, and parameterization sensitivities

Effective radiative forcing from emissions of reactive gases and aerosols – a multi-model comparison

Robust Observational Constraint of Uncertain Aerosol Processes and Emissions in a Climate Model and the Effect on Aerosol Radiative Forcing

Constraining the influence of natural variability to improve estimates of global aerosol indirect effects in a nudged version of the Community Atmosphere Model 5

Effective Radiative Forcing of Anthropogenic Aerosols in E3SM Version 1: Historical Changes, Causality, Decomposition, and Parameterization Sensitivities

Supplementary Material to &quot;model Evaluation of Short-Lived Climate Forcers for the Arctic Monitoring and Assessment Programme: a Multi-Species, Multi-Model Study&quot;

Supplementary Material to &quot;a Global Analysis of Climate-Relevant Aerosol Properties Retrieved from the Network of GAW Near-Surface Observatories&quot;

Using Climate Model Simulations to Constrain Observations

Combining temperature and precipitation to constrain the aerosol contribution to observed climate change

The role of anthropogenic aerosols in the anomalous cooling from 1960 to 1990 in the CMIP6 Earth system models

Contributions of greenhouse gases and solar activity to global climate change from CMIP6 models simulations

Supplementary Material to &amp;quot;surprising Similarities in Model and Observational Aerosol Radiative Forcing Estimates&amp;quot;