Abstract:It is of great significance for structural design and engineering evaluation to obtain the elastic–plastic parameters of materials. The inverse estimation of elastic–plastic parameters of materials based on nanoindentation technology has been applied in many pieces of research, but it has proved to be difficult to determine the elastic–plastic properties of materials by only using a single indentation curve. A new optimal inversion strategy based on a spherical indentation curve was proposed to obtain the elastoplastic parameters (the Young's modulus E, yield strength σy, and hardening exponent n) of materials in this study. A high-precision finite element model of indentation with a spherical indenter (radius R = 20 μm) was established, and the relationship between the three parameters and indentation response was analyzed using the design of experiment (DOE) method. The well-posed problem of inverse estimation under different maximum indentation depths (hmax1 = 0.06 R, hmax2 = 0.1 R, hmax3 = 0.2 R, hmax4 = 0.3 R) was explored based on numerical simulations. The results show that the unique solution with high accuracy can be obtained under different maximum press-in depths (the minimum error was within 0.2% and the maximum error was up to 1.5%). Next, the load-depth curves of Q355 were obtained by a cyclic loading nanoindentation experiment, and the elastic–plastic parameters of Q355 were determined by the proposed inverse-estimation strategy based on the average indentation load-depth curve. The results showed that the optimized load-depth curve was in good agreement with the experimental curve, and the optimized stress–strain curve was slightly different from the tensile test, and the obtained parameters were basically consistent with the existing research.

Determination of Material Properties Via Inverse Techniques

An Overview on Material Parameter Inverse and Its Application to Miniaturized Testing at Elevated Temperature

Analytical and inverse method for determining high temperature properties of materials using small punch creep: a review

EXPERIMENT-BASED INVERSE / IDENTIFICATION METHOD AND ITS APPLICATION TO STUDY ON MATERIAL MECHANICS PROPERTIES

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

Identification of Material Properties Using Indentation Test and Shape Manifold Learning Approach

Determination of Creep Damage Properties from a Miniature Three Point Bending Specimen Using an Inverse Approach

Determination of Creep Parameters from Indentation Creep Experiments: A Parametric Finite Element Study for Single Phase Materials

An Inverse Approach to Determine the Mechanical Properties of Elastoplastic Materials Using Indentation Tests

Extraction of the Anisotropic Plasticity of Metal Materials by Using Inverse Analysis and Dual Indentation Tests

A novel deep-learning-based objective function for inverse identification of material properties

A Creep Finite Element Analysis of Indentation Creep Testing in Two Phase Microstructures (Particle/matrix- and Thin Film/substrate-Systems)

An inverse method for material parameters in metal forming

Assessment of Mechanical Properties of Incoloy800h by Means of Small Punch Test and Inverse Analysis

Identification of Creep Damage Properties of Coating Via a Compound Miniaturized Testing Method and an Inverse Approach

A computational inverse technique to determine the dynamic constitutive model parameters of concrete

An inverse determination method for strain rate and temperature dependent constitutive model of elastoplastic materials

Study on the Identifiability of Material Properties Using Solely the Residual Imprint in Instrumented Indentation Experiment

Research on Determining Elastic–Plastic Constitutive Parameters of Materials from Load Depth Curves Based on Nanoindentation Technology

Image-based inverse characterization of in-situ microscopic composite properties

Material Characterization Based on Instrumented Indentation