Abstract:Establishing a material constitutive model reflecting the mechanical behavior of metal materials in the cutting process is the basis of cutting finite element simulation, and has an important guiding role in accurately describing the cutting thermo-mechanical coupling state variables and further optimizing process parameters. This paper proposes a reverse identification method of material constitutive parameters based on co-simulation. The influence of mass scaling factor, mesh size, and Johnson-Cook (J-C) constitutive parameters on cutting force was analyzed, and orthogonal cutting experiments were carried out for two difficult-to-machine materials, die steel H13 and titanium alloy Ti-6Al-4V. ABAQUS is redeveloped based on Python, and then the J-C constitutive parameters are directly optimized for the first time with the minimum error between the finite element simulation value and the experimental value of the cutting force as the objective function, the least square identification of J-C constitutive parameters based on co-simulation is realized by combining genetic algorithm. The results show that the reasonable setting of mass scaling factor and mesh size can significantly reduce the time of simulation calculation and improve the optimization efficiency of constitutive parameters. The yield stress, hardening coefficient, strain rate coefficient, hardening coefficient and softening coefficient of materials have different effects on cutting force, which is the key to effective inverse identification of constitutive parameters. Compared with different J-C parameters reported in the literature, it is found that the constitutive parameters obtained by inverse identification based on co-simulation are more accurate, and the prediction of residual stress and serrated chip characteristics also has good accuracy. This study provides a reference for the optimization of constitutive parameters, and the research results provide a new scheme for the efficient construction of material mechanical behavior required for cutting finite element simulation.

An Overview on Material Parameter Inverse and Its Application to Miniaturized Testing at Elevated Temperature

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

Real-time Evaluating Temperature-Dependent Interfacial Shear Strength of Thermoplastic Composites Based on Stress Impedance Effect of Magnetic Fibers

Identification of material parameters in low-data limit: application to gradient-enhanced continua

Yield Strength Analysis by Small Punch Test Using Inverse Finite Element Method

A Practical Inverse Identification of Johnson–Cook Parameters at Intermediate Strain Rates Using Split Hopkinson Pressure Bar Test

Assessment of Mechanical Properties of Incoloy800h by Means of Small Punch Test and Inverse Analysis

Advances on in Situ TEM Mechanical Testing Techniques: a Retrospective and Perspective View

An Inverse Approach to Determine the Mechanical Properties of Elastoplastic Materials Using Indentation Tests

An overview on recent development of impression creep test

A miniaturized thin‐plate low cycle fatigue test method at elevated temperature

A novel deep-learning-based objective function for inverse identification of material properties

Material damage evaluation and life prediction via small punch test technology

Inertia-based identification of elastic anisotropic properties for materials undergoing dynamic loadings using the virtual fields method and heterogeneous impact tests

Material model calibration through indentation test and stochastic inverse analysis

Inverse Identification Method for Determining Stress–strain Curves of Sheet Metals at High Temperatures

Identification of material parameters at high strain rates using ballistic impact tests and inverse finite element analysis

Inverse identification of material constitutive parameters based on co-simulation

Miniature Tensile and Small Punch Testing: Mechanical Performance and Application in Hydrogen Embrittlement Analysis

Research on Determining Elastic–Plastic Constitutive Parameters of Materials from Load Depth Curves Based on Nanoindentation Technology

Uncertainties in and Recommendations to Small Punch Tensile and Creep Tests for Ductile Materials