Abstract:The effects of three kinds of oxygenated fuel blends—i.e., ethanol-gasoline, n-butanol-gasoline, and 2,5-dimethylfuran (DMF)-gasoline-on fuel consumption, emissions, and acceleration performance were investigated in a passenger car with a chassis dynamometer. The engine mounted in the vehicle was a four-cylinder, four-stroke, turbocharging gasoline direct injection (GDI) engine with a displacement of 1.395 L. The test fuels include ethanol-gasoline, n-butanol-gasoline, and DMF-gasoline with four blending ratios of 20%, 50%, 75%, and 100%, and pure gasoline was also tested for comparison. The original contribution of this article is to systemically study the steady-state, transient-state, cold-start, and acceleration performance of the tested fuels under a wide range of blending ratios, especially at high blending ratios. It provides new insight and knowledge of the emission alleviation technique in terms of tailoring the biofuels in GDI turbocharged engines. The results of our works showed that operation with ethanol–gasoline, n-butanol–gasoline, and DMF–gasoline at high blending ratios could be realized in the GDI vehicle without any modification to its engine and the control system at the steady state. At steady-state operation, as compared with pure gasoline, the results indicated that blending n-butanol could reduce CO2, CO, total hydrocarbon (THC), and NOX emissions, which were also decreased by employing a higher blending ratio of n-butanol. However, a high fraction of n-butanol increased the volumetric fuel consumption, and so did the DMF–gasoline and ethanol–gasoline blends. A large fraction of DMF reduced THC emissions, but increased CO2 and NOX emissions. Blending n-butanol can improve the equivalent fuel consumption. Moreover, the particle number (PN) emissions were significantly decreased when using the high blending ratios of the three kinds of oxygenated fuels. According to the results of the New European Drive Cycle (NEDC) cycle, blending 20% of n-butanol with gasoline decreased CO2 emissions by 5.7% compared with pure gasoline and simultaneously reduced CO, THC, NOX emissions, while blending ethanol only reduced NOX emissions. PN and particulate matter (PM) emissions decreased significantly in all stages of the NEDC cycle with the oxygenated fuel blends; the highest reduction ratio in PN was 72.87% upon blending 20% ethanol at the NEDC cycle. The high proportion of n-butanol and DMF improved the acceleration performance of the vehicle.

Effects of Ethylhexyl Nitrate, Diesel and Gasoline Blends on Diesel Engine Performances: from Engine Experiment to Vehicle Test

The Effects of Ethylhexyl Nitrate on the Performance of Diesel Engine Fueled with Diesel and Gasoline Blends: from Engine Bench Test to Vehicle Driving Cycle Test

Engine Performance and Emissions of A Compression Ignition Engine Operating on the Diesel-Methanol Blends

Environmental and performance impacts of 2-ethylhexyl nitrate and ethanol in diesel blends: A comprehensive study

Investigation on Blending Effects of Gasoline Fuel with N-Butanol, DMF, and Ethanol on the Fuel Consumption and Harmful Emissions in a GDI Vehicle

Effect of Adding EHN in Wide Distillation Fuel on Combustion and Emission Characteristics of Engine

Detailed experimental investigation and optimization of oxygenated diglyme–diesel–n-pentanol ternary blends on compression ignition engine behaviors

Combustion Process and Emissions of A Heavy-Duty Engine Fueled with Directly Injected Natural Gas and Pilot Diesel

Effects of Hydrogen Addition on the Performance of a Pilot-Ignition Direct-Injection Natural Gas Engine: A Numerical Study

A numerical investigation on the effects of gaseous fuel composition in a pilot ignited direct injection natural gas engine

Influence of fuel system variations on performance and emission characteristics of combined air-wall-guided mode modified GDI engine with alcoholic fuels and exhaust gas recirculation

Effects of low-carbon high-reactivity fuels on combustion and emission characteristics in a part-load condition of a DICI engine

Comparative study on Gasoline Homogeneous Charge Induced Ignition (HCII) by diesel and Gasoline/Diesel Blend Fuels (GDBF) combustion

Use of 2-methoxyethyl ether and nitromethane as oxygenated additives for performance improvement and emission reduction of CI engine: experimental investigation and numerical simulation

Computational study on the impact of gasoline-ethanol blending on autoignition and soot/NOx emissions under low-load gasoline compression ignition conditions

Combustion and Emission Characterization of a CRCI Engine Fueled by Cyclopentanol/Diesel Blends and Verification Through Real-Time Vehicle Test

Effect of Different Ratios of Gasoline-Ethanol Blend Fuels on Combustion Enhancement and Emission Reduction in Electronic Fuel Injection Engine

Effects of Intake Components on Combustion and Emission Characteristics in an n -Butanol/Diesel Blend Fueled Engine

Experimental analysis on combustion, performance and emission characteristics of exo-THDCPD/diesel blends in a compression ignition engine

Influence of Ethanol Blended Diesel Enriched with Hydroxy Gas in Dual-Fuel Mode on Common Rail Direct Injection Engine

Comparative evaluation of different operating parameters on performance, combustion, and emission characteristics in gasoline compression ignition (GCI) engine by using carbon neutrally biofuels