Abstract:According to the International Electrotechnical Commission, medium voltage ranges from 1 kV to 36 kV. In this voltage range, the field of power electronics has been focusing on developing power converters with high efficiency. Converters for such applications include solid-state transformers, energy storage systems for vehicle charging, electric aircraft, etc. Power ranges could reach tens to hundreds of kilowatts at relatively high frequency (10–50 kHz). Currently, there are no high-frequency power semiconductors capable of switching these voltage levels. Instead of using a single power switch, a string of power switches is used. The upper switches in the string require special attention because they need the highest isolation capabilities and a floating control signal and power supply for the gate driver. Many techniques have been proposed to accomplish this, but they commonly use separate circuits for the control signal and the power supply, increasing the cost, size, and complexity of the gate driver. This paper presents a gate driver for medium voltage with high-voltage isolation capabilities in a single structure for the control signal and the power supply. The proposed gate driver uses a resonant converter that transmits power within the gate driver information. A demodulator separates the gate driver information from the power signal, obtaining the power supply and the control signal for the switch. The paper includes simulation and experimental results that demonstrate the viability of the proposal. The experimental results show the principal features of the gate driver, achieving improvements in complexity, isolation capabilities, and both rise and fall times for large input capacitances of power semiconductor switches. The proposed gate driver presents a rise time of 44 ns and a fall time of 46 ns for the gate input capacitance of currently available SiC MOSFETs. The isolation barrier uses a 25 mm air gap, achieving an isolation capability of approximately 68.2 kV, which exceeds the requirements for MV applications.

Dual-Channel Isolated Gate Driver Power Supply Based on Ultrasonic Power Transmission Technology

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

A New Hybrid Gate Drive Scheme for High Frequency Buck Voltage Regulators

A Novel Single Power-Supply IGBT Driver Circuit

Design of Ultrasonic Isolation Wireless Power Supply for Gate Drive Circuit of Module Multi-level Converter

Isolated Gate Driver for Medium Voltage Applications Using a Single Structure

A Novel Single Isolation Channel Gate Driver with Bi-Directional-Signal and Forward-Power Transmission

An Integrated Magnetically Isolated Gate Driver Architecture for SiC MOSFET Applications

Design and Optimization of High Performance Gate Driver for Medium-Voltage SiC Power Modules

A Power Supply Solution for High-Voltage IGBT Drivers

MHz Level Two-Stage ZVS DC-DC Converter with Wide Input and Output Voltage Ranges

A Novel Isolated Gate Driver Power Supply Method for Self-powered SiC DC Solid-State Switch Using Thermoelectric Generation

An Active Gate Driver for Dynamic Current Sharing of Paralleled SiC MOSFETs

High-Density Current-Transformer-Based Gate-Drive Power Supply With Reinforced Isolation for 10-kV SiC MOSFET Modules

A 98.3% Efficient GaN Isolated Bidirectional DC–DC Converter for DC Microgrid Energy Storage System Applications

A Monolithic GaN Driver and GaN Power Switch with Power-rail Charging Saturation Bootstrap technique achieving gate rising and falling time ratio of 1.28

A Fully Integrated Floating Gate Driver with Adaptive Gate Drive Technique for High-Voltage Applications

Gate Driver Design for Cryogenically Cooled Power Electronic Converters

An Integrated Gate Driver Based on SiC MOSFETs Adaptive Multi-Level Control Technique

A 400-V Half Bridge Gate Driver for Normally-off GaN HEMTs with Effective dv/dt Control and High dv/dt Immunity

A Radiation-hard Gate Driver Circuit for High Voltage Application