Mechanism of Plugging High Permeability Core and Decreasing Reservoir Heterogeneity with Ultra-Dry CO2-in-water Foam

Biao Xu,Yu Yang,Wanghong Long,Jingyi Yang,Tao Liu

DOI: https://doi.org/10.1016/j.fuel.2024.131148

IF: 7.4

2024-01-01

Fuel

Abstract:For oil recovery in low-permeability oil fields, ultra-dry CO2 foam flooding possesses the dual advantages of pure CO2 flooding and surfactant flooding, and is also effective for CO2 storage. Herein, ultra-dry CO2-in-water (C/W) foam with 10 v/v% water content was used for core plugging and to decrease the heterogeneity of oil reservoirs. The resistance coefficient (Rf) and residual resistance coefficient (Rff) characterizing the foam-plugged cores were measured at different foam existence times (different times after forming the foam) and for cores with different permeabilities. As the foam existence time increased, the non-uniformity of the foam intensified, resulting in a decrease in its ability to plug cores. Specifically, the resistance coefficient (Rf) decreased from 12.179 to 6.802, while the residual resistance coefficient (Rff) decreased from 7.149 to 3.809. With a decrease in the core permeability, Rf decreased from 26.525 to 10.398, Rff decreased from 17.313 to 4.230, and the ability of the foam to plug cores decreased, indicating that the ultra-dry C/W foam could effectively plug the high-permeability layer and decreasing the reservoir heterogeneity. Based on the distribution of foam and pore size, three plugging mechanisms were proposed: single-bubble bridge, multi-bubble accumulation and foam compression, deformation and rupture. Additionally, a scale factor I (I = Rff/Rf) was introduced to evaluate the stability of the residual foam in the plugged core. After different existence times, the value of I for the foam injected into the core was stable at 0.55-0.6, indicating good stability of the foam. Finally, oil recovery in parallel cores was evaluated and two-phase flow was simulated based on the phase-field method, which further proved that the ultra-dry C/W foam can effectively decrease the reservoir heterogeneity and enhance oil recovery in the low-permeability zone.