ADSORPTION OF ACID BROWN-340 ON SILICA BASED ADSORBENT

Salman Khan

DOI: https://doi.org/10.26434/chemrxiv-2024-7dt0s

2024-02-14

Abstract:Acid Brown-340 is a valuable and prominent dye which Having Serious effect on our environments due to its acidic nature. Usually, this dye is coming out of different industries and accumulate in various water bodies such as lakes, ocean and freshwater ecosystem. In this Present study silica monolith particles were synthesized by the renovated sol-gel process under controlled environment of heating steps. The newly prepared functionalized silica monolith particles were used as an adsorbent for the removal of acid brown-340 from aqueous solution. particles originating from silica monolith were effective adsorbent for the removal of selective dye due to its various sorts such as enlarged surface area, high permeability due to monolith like nature leading to high loading capability, and mechanical strength to various PH. Adsorption capacity of silica was firm with respect to different parameters at certain point of time. By adjusting certain parameter such as PH at range 2-8 Concentration taken as range from 0.02-0.1 and time as taken as range from 15mins to 75mins. Then Acid brown-340 shows the greatest adsorption with particles originating from silica monolith when the optimized values of the parameters for acid brown-340 are PH is 2, adsorbent dose is 0.06g, and Contact time is 75 min.

Chemistry

What problem does this paper attempt to address?

The paper mainly discusses the use of silicon-based adsorbents (silica gel-based microparticles) to remove Acid Brown 340 dye from aqueous solutions. Acid Brown 340 is an environmentally harmful acid dye commonly found in various industrial wastewater. The study synthesized a new type of functional silica gel-based microparticles through the sol-gel process under controlled heating conditions, and used them as adsorbents.

Different parameters, such as pH value, adsorbent dosage, and contact time, were experimentally investigated for their effects on the adsorption efficiency. The results showed that the optimal adsorption conditions were pH 2, adsorbent dosage of 0.06 grams, and contact time of 75 minutes. The adsorption process mainly relied on the interaction between dye molecules and the adsorbent surface, and pH value had a significant influence on the adsorption due to the variation of the charge state on both dye and adsorbent surfaces. The adsorbent dosage and contact time also affected the adsorption efficiency, with increasing dosage and prolonged time leading to higher dye removal, but there existed an optimal value.

Based on these experiments, the authors concluded that silica gel-based microparticles are effective and cost-efficient adsorbents for removing acid dyes from wastewater treatment, contributing to alleviating environmental pollution. This work provides insights into the dye adsorption mechanism and may serve as a reference for the development of more efficient water treatment technologies.