Abstract:The as-laid embedment is a key design element of deep-water pipelines, as it significantly affects the longitudinal and transverse pipe-soil interaction and thermal insulation. Due to the small-amplitude oscillations driven by the sea state as well as lay vessel motions, the as-laid embedment is significantly greater than the predictions derived from static penetration analyses. This paper presents a numerical study into the cyclic embedment behavior of deep-water pipelines in soft clay using a recently developed sequential limit analysis (SLA) technique. It directly models the evolution of model geometry and material properties through a consecutive series of small displacement analyses and incorporates the effect of strain softening and strain rate on soil strength. A rigid plane-strain pipe section is pushed-in-place and then subjected to small-amplitude cyclic lateral displacements, with an accumulated lateral pipe displacement of up to 60 diameters. Careful comparisons between the numerical results with published centrifuge data are provided to demonstrate the robustness of SLA, in terms of pipe invert trajectory and soil resistance, followed by an extensive parametric study investigating the effect of strain rate, strain softening, oscillation amplitude, and loading history. More detailed aspects of the cyclic loading behavior are discussed with reference to soil failure mechanisms and bearing capacity yield envelopes. A strong correlation between accumulated lateral pipe displacement and pipe embedment is identified, regardless of the varying oscillation amplitudes, and soil buoyancy is found to play the most significant role in determining the final pipe embedment. The present study aims to assist the development of a macro-element plasticity pipe-soil model that can be incorporated into simplified three-dimensional (3D) pipeline-seabed models, as well as to promote the application of SLA to model complex large-displacement pipe-soil interaction problems.

Extension and Validation of Sequential Limit Analysis for Geotechnical Problems

Modelling lateral pipe-soil interaction on soft clay using large displacement sequential limit analysis

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

J2-deformation-type Soil Model Coupled with State-Dependent Dilatancy and Fabric Evolution: Multiaxial Formulation and FEM Implementation

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Modelling T-bar Penetration in Soft Clay Using Large-Displacement Sequential Limit Analysis

Numerical Modelling of Pipe-Soil Interaction for Marine Pipelines in Sandy Seabed Subjected to Wave Loadings

Numerical modelling on effect of loading rate on uplift behavior of suction caissons

Large Deformation Finite Element Analysis on Excavated Slopes

Extended DDA with Rotation Remedies and Cohesive Crack Model for Simulation of the Dynamic Seismic Landslide

Evaluating Slope Stability with 3D Limit Equilibrium Technique and Its Application to Landfill in China

Stability Analysis of Overconsolidated Unsaturated Red Clay Slope Based on Modified UH Model

An Operator‐split ALE Model for Large Deformation Analysis of Geomaterials

Behavior Analysis of Laterally Loaded Single Pile under Large Deflection

Stability analysis of slope in strain-softening soils using local arc-length solution scheme

Degradation-damage model application for landslide accumulation stability and reinforcement optimization in Southeast Xizang: a case study

Method of strain analysis of pipelines under landslides: An improved semi-analytical method for softening bending moment-curvature

Development of an SPH-based method to simulate the progressive failure of cohesive soil slope

Effect of Swelling Deformation on Stability of Expansive Soil Slope

Modeling of Initial Stresses and Seepage for Large Deformation Finite-Element Simulation of Sensitive Clay Landslides