Abstract:Large degradation in thermal insulation and strain tolerance is a main headache and a primary cause of the failure for plasma-sprayed thermal barrier coatings (TBCs) during service. One mechanism behind such degradation is the healing of interlamellar pores formed by multiple connections between edges of a pore, which significantly speeds up healing during thermal exposure. The objective of this study is to obtain sintering-resistant TBCs by tailoring the width of interlamellar pores to avoid multiple connections. Firstly, the mechanism responsible for the multiple connections was revealed. The splat surfaces before and after thermal treatments were characterized via an atomic force microscope (AFM). The roughening of the pore surface occurs during thermal exposure, along with the grain growth inside the splats. Consequently, the local surface height increases, which causes multiple connections and healing of the interlamellar pores. Secondly, critical widths of the interlamellar pores for avoiding the multiple connections during thermal exposure are established by correlating the extent of surface roughening with the growth of individual grains. The height increase of the splat surface and the growth of the grain size (D) were found to increase with the exposure temperature and duration. A relationship linking the height increase and the growth of the grain size induced by thermal exposure in plasma-sprayed ceramic splats was obtained. Finally, composite TBCs were prepared to form wide interlamellar pores in the coatings. Using this design, the increases in the thermal conductivity (.) and the elastic modulus (E) can be prevented to a large extent. Thus, sintering-resistant TBCs that maintain high thermal insulation and strain tolerance, even after long thermal exposure, can be created.

Relationship Between Pores on Thermal Sprayed Thermal Barrier Coatings and Coating Properties

Multiscale Pores in TBCs for Lower Thermal Conductivity

Influence of Pores on the Thermal Insulation Behavior of Thermal Barrier Coatings Prepared by Atmospheric Plasma Spray

Effect of spraying ceramic powder pore structure on thermophysical properties of plasma-sprayed thermal barrier coatings

Dominant Effect of Oriented 2D Pores on Heat Flux in Lamellar Structured Thermal Barrier Coatings

Numerical Analysis of the Influence of Pore Microstructure on Thermal Conductivity and Young's Modulus of Thermal Barrier Coating

Influences of the Near-Spherical 3D Pore on Failure Mechanism of Atmospheric Plasma Spraying TBCs Using a Macro-Micro Integrated Model

Effect of Pore Evolution on Thermal Diffusivity and Radiation Characteristics of Thermal Barrier Coatings after High-Temperature Exposures

Effect of the Microstructural Design of Plasma-Sprayed Thermal Barrier Coatings on Its the Thermal Cycling Behaviour

A matching design co-enhancing thermal barrier and thermal cyclic performances of sintering-resistant coatings

Tailoring Sintering-Resistant Thermal Barrier Coatings by Considering Critical Healing Width of Two-Dimensional Interlamellar Pores

Enhanced Thermal Isolation in Porous Thermal Barrier Coatings by the Formation of Pore Guided Thermal-Shock Cracks

Effect of Different Types of Pores on Thermal Conductivity of YSZ Thermal Barrier Coatings

Achieving high anti-sintering performance of plasma-sprayed YSZ thermal barrier coatings through pore structure design

Tailoring degradation-resistant thermal barrier coatings based on the orientation of spontaneously formed pores: From retardation to self-improvement

Dominant effects of 2D pores on mechanical behaviors of plasma sprayed ceramic coatings during thermal exposure

Effect of sintering on stress distribution of thermal barrier coatings for high temperature blade

Heredity and Variation of Hollow Structure from Powders to Coatings Through Atmospheric Plasma Spraying

Control of the Pore Structure of Plasma-Sprayed Thermal Barrier Coatings Through the Addition of Unmelted Porous YSZ Particles

Durable Columnar Structure Design for Thermal Barrier Coatings

Quantitative Analysis of Pores in Plasma-sprayed ZrO_2 Coatings