Quantitative Analysis for the Displacement of Tent-Shaped Surface Relief of Lath Martensite in Fe-Based Alloy
Wu Jing,Liu Xinxin,Gu Xinfu,Dai Fuzhi,Yang Haitao,Zhang Wenzheng
IF: 1.797
2009-01-01
ACTA METALLURGICA SINICA
Abstract:Lath martensite with a dislocation substructure is one of the most common forms of martensite in structural steels. Surface relief has been regarded as an important characteristic in the martensitic transformation. Crystallographic features on surface relief are essential to get into deep insight of the long range strain field in the transformation, and explore the mechanism of the phase transformation. However, very limited experimental data on the shape strain associated with the formation of surface relief caused by the lath martensite have been reported so far, especially for the quantitative study of the displacement; vector. The present investigation was carried out to study the shape deformation in the formation of the lath martensite on the austenite matrix in an Fe-20.2Ni5.5Mn (mass fraction, %) alloy. The shape strain accompanying surface relief, such as the magnitude and direction of the displacement vector, has been concerned in a quantitative way. The morphology of the relief was studied by the optical microscope (OM) and the atomic force microcope (AFM). The orientations of the matrix grain and the lath were measured by the electron backscattered diffraction (EBSD), respectively, which was used to determine the orientation of the habit plane, and the orientation relationship (OR) between the lath martensite and its neighboring matrix. Combing the data from EBSD and AFM, it is concluded that the relief is produced by a single bee crystal, which exhibits a tent-shaped relief. Based on an electron backscattered diffraction analysis, the austenite/martensite orientation relationship is found to be in the closer vicinity of K-S orientation relationship, which is consistent with that in bulk materials obtained by transmission electron microscope (TEM), and the habit plane is determined to be near (1 (1) over bar(1) over bar)(f). The largest shear angle for the relief is calculated to be 27.49 degrees, and the directions of combined displacement vector are scattered around [12 (1) over bar](f). However, the observed maximum surface tilt angle is 22.41 degrees, which is smaller than the calculated value. Considering the habit plane is not perpendicular to the pre-polishing surface, the measured smaller value of tilt angles is reasonable.