Abstract:The photoelectron spectroscopy beamline at National Synchrotron Radiation Laboratory (NSRL) is equipped with a spherical grating monochromator with the included angle of 174 deg. Three gratings with line density of 200, 700 and 1200 lines/mm are used to cover the energy region from 60 eV to 1000 eV. After several years operation, the spectral resolution and flux throughput were deteriorated, realignment is necessary to improve the performance. First, the wavelength scanning mechanism, the optical components position and the exit slit guide direction are aligned according to the design value. Second, the gratings are checked by Atomic Force Microscopy (AFM). And then the gas absorption spectrum is measured to optimize the focusing condition of the monochromator. The spectral resolving power is recovered to the designed value of 1000@244eV. The flux at the end station for the 200 lines/mm grating is about 10^10 photons/sec/200mA, which is in accordance with the design. The photon flux for the 700 lines/mm grating is about 5 X 10^8 photons/sec/200mA, which is lower than expected. This poor flux throughput may be caused by carbon contamination on the optical components. The 1200 lines/mm grating has roughness much higher than expected so the diffraction efficiency is too low to detect any signal. A new grating would be ordered. After the alignment, the beamline has significant performance improvements in both the resolving power and the flux throughput for 200 and 700 lines/mm gratings and is provided to users.

Synchrotron Radiation Lithography and MEMS Technique at NSRL

Manufacturing technology by synchrotron radiation in NSRL

X-ray microscopy instrumentation developments at NSLS-II: recent progress and future directions

Micro/Nanomanufacturing in Support of Materials Science

SYNCHROTRON-RADIATION-SUPPORTED HIGH-ASPECT-RATIO NANOFABRICATION

Soft X-ray and EUV monochromator development at NSRL

Soft X-ray microscopy using the synchrotron radiation from the NSRL at Hefei

X-Ray Optics R&D At Nslsii Focus On Optical Metrology Development

Soft X-ray Holography at NSRL

Electron Beam Lithography Application on the Nanofabrication and Nanodevice

The Application of Optical Resolution Enhancement Technology and E-Beam Direct Writing Technology in Microfabrication

Hybrid micro/nano-structure formation by angular laser texturing of Si surface for surface enhanced Raman scattering.

Performance of the undulator based ultraviolet and soft x-ray beamline for catalysis and surface science at National Synchrotron Radiation Laboratory

Advanced nano-lithography technology

Implementation of Soft X-Ray Microscopy with Several Tens Nanometers Spatial Resolution at NSRL

Alignment of the photoelectron spectroscopy beamline at NSRL

Construction and Preliminary Application of Soft X-ray Magnetic Circular Dichroism Endstation at NSRL

A strategy to fabricate nanostructures with sub-nanometer line edge roughness

Novel 3-D Device Fabrication Process in Micro-Electronic Mechanical System Based on Nano-Imprint Lithography

Grating Monochromator Related Techniques

Preparation of High-Quality Colloidal Mask for Nanosphere Lithography by a Combination of Air/Water Interface Self-Assembly and Solvent Vapor Annealing