Numerical Study of Blade Roughness Effect on Cavitation in Centrifugal Pumps
Basel Al Bishtawi,Gianfranco Scribano,Manh-Vu Tran
DOI: https://doi.org/10.1088/1742-6596/2051/1/012047
2021-10-01
Journal of Physics: Conference Series
Abstract:Abstract Cavitation is classified as an undesirable complex multiphase phenomenon due to its negative effects on the structural and flow behaviours of hydraulic machineries, specifically centrifugal pumps. Typically, the pump’s cavitation performance tends to vary due to a multitude of factors, one of which is the impeller blade roughness. In this study, a numerical analysis is conducted, using ANSYS Fluent 20.1, to evaluate the relationship between the impeller blade roughness and the cavitation performance of an ISO 80-50-250 centrifugal pump operating at different pressures and flow rates. The operating conditions include net positive suction head (NPSH) values set at 20, 7.25, 5.71, 2.58, 1.1 m along with outlet mass flow rates of 40, 50, 60 m3/h while the blade roughness height value is changed to 1, 20, 80 μm. The SST k-ω turbulence model, along with the Zwart-Gerber-Belamri cavitation model is used. The results showed that the pressure head increased by approximately 1.64%, 1.55%, and 1.90% at flow rates of 40, 50, and 60 m 3 /h when the roughness height was increased from 0 μm to 80 μm. However, the increase in roughness improved cavitation inception simultaneously. Meanwhile, the blade suction-side witnessed a delay in cavitation formation, as it shifted downstream towards the trailing edge from its initial point of formation at the blade passage.